Abstract:The cavitation damage in the Engine cooling water pump (ECWP) is the key factor that shortens the lifespan of automobile cooling systems, and causes vibration and noise. To improve cavitation performance and external characteristics of ECWP, three optimized models were designed on the basis of WP7 diesel ECWP. The whole flow fields in three models and the prototype pump were numerically simulated, employing the time averaged Navier-Stokes equation, the standard k-ε turbulent model and Zwart-Gerber-Belamri multiphase flow model by ANSYS-CFX software. Pressure distribution, turbulent kinetic energy distribution, bubble volume fraction distribution, external characteristics and cavitation performance of the prototype pump and optimized models were compared and analyzed. The results show that the external characteristics and cavitation performance of the optimized models are significantly better than that in the prototype pump. Through decreasing the inlet blade angle and wrap angle, extending the blade to inlets and extending a certain inclination in the blade, shock loss in blade inlet was reduced and so, the performance of pump will be improved. The flow condition at blade inlet will also be improved greatly, which in turn improves cavitation performance. When reducing the quantity of blades, the excretion coefficient will drop, flow area of blade inlet becomes bigger, but head has a little drop. And the pump optimized by reducing the quantity of blades has the optimal cavitation performance among three optimized models. With the decrease of impeller diameter, the absolute pressure in the critical cavitation point becomes bigger, the inlet bubble volume fraction at the same absolute pressure increases while cavitation performance gets worse. The obtained numerical results were compared with the experimental ones, and the outcome showed the same tendency between the two along with acceptable error.

Case Analysis on General Design of Engine Water Pump

Experimental Research on Performance of Water Hydraulic Internal Gear Pump

Parametric Design of Water Hydraulic Axial Piston Pump's Main Inner Parts

Analysis of force and leakage in water hydraulic motor' s piston pairs

Hydraulic Optimization of Super-low Specific Speed Multistage Flameproof Submersible Pump with Inner Motor for Coal Mine

Theoretical Analysis of a Water Hydraulic Internal Ball Gear Pump

Comparison of Electrical and Mechanical Water Pump Performance in Internal Combustion Engine

The Optimization of A Low Specific Speed Pipeline Pump

Improvement Design of a Vertical Double-stage Self-priming Pump

Hydraulic performance prediction and optimization of an engine cooling water pump using computational fluid dynamic analysis

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Impeller design criterion based on numerical simulation of stock pump flow field and its application

Design Method of Water Jet Pump Towards High Cavitation Performances

Leakage and Volumetric Efficiency Analysis and Seal Improvement of Internal Gear Pump with Multi Output

Analysis of the Influence Laws of Inlet Condition on the Volumetric Efficiency of the High-Speed Fuel Gear Pump

Multistage auxiliary-impeller performance analysis and its application

Strength Analysis and Optimal Design of the Pump Case Based on the Combined Action of Thermal Stress and Water Pressure

Development of small-flow high-head high-speed centrifugal pump

Numerical Investigation on Pairing Solutions of Non-Positive Displacement Pumps and Internal Gear Pump for High-Speed Design

Improvement Design of a Two-Stage Double-Suction Centrifugal Pump for Wide-Range Efficiency Enhancement

Numerical calculation and optimization designs in engine cooling water pump