Abstract:Vortex pumps have good non-clogging performance and are widely used in the fluid transportation of food, sewage treatment, and mineral and coal slurry transportation. In order to design and manufacture a vortex pump with good performance and establish a method of optimum design, we must master the internal flow rules of the pump. Based on the self-design vortex pump (32WB8-12) experiment, the discharge-pump head (qv-H), discharge-pump shaft power (qv-P), discharge-pump efficiency (qv-η), and discharge-critical net positive suction head (qv-NPSHc) curves are obtained, and the qv-NPSHc curve shows an opposite tendency compared with the centrifugal pump. With the mathematical model selected with respect to the optimal condition, the three-dimensional internal flow within the vortex pump has been numerically simulated by a renormalization group k-ε (RNG k-ε) turbulence model. The static pressure (ps) and velocity distribution of the impeller and the middle section of the volute at 0°, 90°, 180°, and 270° are obtained, and the performance curves have been fitted using a CFX-calculated energy parameter. It was illustrated that the velocity field is relatively disordered and the flow in the impeller region is of a forced vortex character. The flow in the volute is similar to that of the combined vortex with backflow, which is a non-axisymmetric unsteady flow with quite high turbulence intensity. These factors are the main reasons for the relatively low efficiency of the vortex pump. The measurement of flow field in volute with a five-hole probe was conducted, and it is demonstrated that the numerical results are in good agreement with the flow field measurement data. An upward pressure gradient forms in the portal area of the impeller, and it is confirmed that the lowest pressure point is located in the upper position of the impeller hub. It is revealed that for the vortex pump to have advanced suction and anti-cavitation performance, the lowest pressure in the pump should be −4 × 104 Pa and it should be located at the center of the vortex chamber cavity.

Development of small-flow high-head high-speed centrifugal pump

The Optimization of A Low Specific Speed Pipeline Pump

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

The development of a high-speed miniature pump with dynamic bearing

A Performance Test and Internal Flow Field Simulation of a Vortex Pump

Optimization Study on a Novel High-Speed Oil-Free Centrifugal Water Pump with Hydrodynamic Bearings

Study On Transient Hydrodynamic Performance And Cavitation Characteristic Of High-Speed Mixed-Flow Pump

Optimal design of centrifugal pump with large power and high pressure

Hydraulic Optimization and Loss Analyses of a Low Specific-Speed Centrifugal Pump with Variable-Thickness Blades

Study on High-Speed Centrifugal-Regenerative Pump with an Inducer

Improvement Design of a Vertical Double-stage Self-priming Pump

High Efficiency and Low Pressure Fluctuation Redesign of A Centrifugal Pump Based on Unsteady Cfd Analyses

Review of Progress on the Design Technology of Centrifugal Type Chemical Process Pump

Computational Fluid Dynamics-Based Pump Redesign to Improve Efficiency and Decrease Unsteady Radial Forces

Design, Fabrication and Characterization of A Mechanical Micropump

Impeller design criterion based on numerical simulation of stock pump flow field and its application

Numerical Investigation on Pairing Solutions of Non-Positive Displacement Pumps and Internal Gear Pump for High-Speed Design

Design optimization of the impeller for a high specific-speed pump based on BVF diagnosis

Design and Improvements of Centrifugal Pumps with Low Specific Number of Speeds Based on Inner Flow Analysis

Study on a high-speed oil-free pump with fluid hydrodynamic lubrication

Application and Challenge of High-Speed Pumps with Low-Temperature Thermosensitive Fluids