Abstract:Introduction. The relevance of the presented paper is due to the widespread use of plunger pumps in industrial practice, in particular, in gas and oil production. The quality of working operations and the efficiency of further well operation depend largely on their reliability. The improvement of plunger pumps involves increasing their reliability, increasing their service life, efficiency, downsizing, reduction in weight, labor intensity of installation and repair work. The modernization of the mechanism includes its power study since the found forces are used for subsequent strength calculations. Before the appearance of programs for the numerical analysis of solid objects, the analytical solution to the problem of strength calculation of the high-pressure pump drive frame was a very time-consuming and expensive procedure. The situation has changed with the development of computer technologies and the inclusion of the finite element method in the computer-aided design systems. The objective of this work is to perform a strength calculationon the TWS 600 plunger pump body made of 09G2S steel. Materials and Methods. A method for determining the reactions of the crank shaft supports of a high-pressure plunger pump and strength calculation of the drive part housing is developed. The direction and magnitude of the resulting forces and reactions of the supports are determined graphically according to the superposition principle of the force action on the supports. Strength calculations were performed using the finite element method in the computer-aided design system Solid Works Simulation. In this case, solid and finite-element models of the body with imposed boundary conditions were used, which were identified during the analysis of the design and the calculation of the forces arising under the pump operation. Results. The reactions in the crankshaft supports are described with account for the forces generated by the plunger depending on its operating mode and the crank position. The forces acting on each of the plungers and the resulting reactions in each of the supports are determined. The diagrams of stresses and the safety factor are presented, which provide assessing the strength of the body and developing recommendations for creating a more rational design. Discussion and Conclusions. As a result of the calculations, we have identified areas of the structure with minimum safety factors, and areas that are several times higher than the recommended values. This provides optimizing the designunder study through strengthening the first and reducing the thickness of the metal on the second. From the point of view of weight and size characteristics and maintainability, the results of the strength calculation performed can be used to optimize the design of the pump body under typical operating conditions.

Strength Analysis and Optimal Design of the Pump Case Based on the Combined Action of Thermal Stress and Water Pressure

Water Cooling System Design and Thermal Analysis for Electrical Vehicle Driving Motors

Multi-objective Optimization Design of Sliding Bearing of High-speed Centrifugal Pump Based on Lubrication Characteristics Analysis

Strength analysis of a large centrifugal dredge pump case

Computation of Stress Distribution in a Mixed Flow Pump Based on Fluid-Structure Interaction Analysis

Optimization of a Centrifugal Boiler Circulating Pump's Casing Based on CFD and FEM Analyses

The Optimization of Bellows Convolutions in Bellows Pump for Better Stress Distribution

Structure Innovation and Material Optimization of Annular Linear Induction Electromagnetic Pump Based on Temperature Field Constraints

Casing modification and stress safety of boiler circulation pumps

Strength analysis of the TWS 600 plunger pump body in Solid Works Simulation

Optimal design of centrifugal pump with large power and high pressure

Stress Analysis of Screw Connection of Key Structural Components in Pump Turbine

Hydraulic performance prediction and optimization of an engine cooling water pump using computational fluid dynamic analysis

Structural characteristics analysis of extra–high–head pump–turbine-unit under extreme-pressure working-conditions

Strength Analysis of Impeller in Automobile Water Pump under the Combined Loads

Design and Optimization Analysis of Composite Water Cooling System Based On High Power Density Motor

Research of Water Jacket Design for Water-cooling Motor

Strength Analysis Based on Coupling Stress of Turbo-Expander Rotor System

Strength Analysis and Structure Optimization of the Crankshaft of an Opposed-Power Reciprocating Pump

Aseismatic strength analysis of main nuclear reactor pump based on real three dimension model

Numerical investigation and optimum design of complex thin-walled structures subject to internal pressure load