Abstract:The geometric complexity and high-pressure gradients that characterize the design of the flow field of gear pumps make it very difficult to obtain an accurate CFD simulation of the component. Usually, assumptions are made both in terms of geometrical features and physics being included in the analysis. The contact between the teeth, which is a key factor for the correct functioning of these pumps, represents a critical challenge in 3D CFD simulations, mainly due to the intrinsic limits of the dynamic meshing techniques that can hardly effectively manage a zero or close to zero gap point forming during gear rotation. The geometric complexity and high-pressure gradients that characterize the gear pump flow field make a CFD analysis quite difficult, and the contact between the gear teeth is usually avoided, thus being an extremely important feature. In this paper, a gear pump composed of inlet and outlet pipes was considered, and the contact between the gear’s teeth was modeled in two different ways, one where it is effectively implemented and one where it is avoided using distancing and a proper casing modification. Herein, a new methodology is proposed for the application of the dynamic mesh method in the Simcenter STAR-CCM+ environment using an adaptive remeshing technique. The proposed methodology is compared with the alternative overset meshing method available in the software. The new meshing method is implemented using a user-routing that reproduces the real geometry of the gears while rotating during the pump operation, with teeth contact included. The routine is optimized in order to limit the additional computation and time needed for the remeshing process. The results that can be obtained using the two meshing approaches for the gear pump are compared in terms of computational effort and the accuracy of the results. The two methods showed opposite results in almost all the reported results, with the overset being more precise in the radial pressure evaluation and the dynamic being more reliable in the cavitation/aeration extension cloud.

Analysis of the Influence Laws of Inlet Condition on the Volumetric Efficiency of the High-Speed Fuel Gear Pump

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Flow Field Modeling and Simulation of High-Speed Gear Pump Considering Optimal Radial and End Clearance

Development of a Numerical Approach for the CFD Simulation of a Gear Pump under Actual Operating Conditions

Influence of the Rotation Speed on the Internal Flow Characteristics of an Aircraft Fuel Gear Pump

Numerical Study of the Hydrodynamics of an External Gear Pump

The Optimization of A Low Specific Speed Pipeline Pump

Cavitation Performance Improvement of High Specific Speed Mixed-Flow Pump

Raising the Speed Limit of Axial Piston Pumps by Optimizing the Suction Duct

Analysis of Pressure Pulsation in Aviation Gear Pump

Numerical simulation and model test of the influence of guide vane angle on the performance of axial flow pump

Numerical and experimental studies on flow performances and hydraulic radial forces of an internal gear pump with a high pressure

Analysis of axial leakage in high pressure involute internal gear pump

Study of a High-Pressure External Gear Pump with a Computational Fluid Dynamic Modeling Approach

Research on the Noise Reduction Method of High Speed Gear Pump Using Inducer to Eliminate Inlet Vortex

Analysis on Oil Film of Hydrostatic Bearing in Gear Pump Operating at High Pressures and High Speeds

A Two-Dimensional Numerical Analysis of a Circular-Arc Gear Pump Operating at High Pressures and High Speeds

Effects of pump parameters on the oil absorption characteristics of bidirectional involute internal gear pumps