Abstract:Purpose. It is to determine the functions of the temperature of the coolant on the time of heating of the cooling system of the small internal combustion engine in two variants – with a coolant pump with a constant mechanical drive, and with an electrical driven pump. Research methods. Methods of analysis of scientific literature and theoretical generalization, methods of statistical analysis, synthesis, observation, method of project development have been used. The graphs were treated with the least squares with the finding a polynomial function of temperature from time. The accuracy of the results is evaluated by the correlation index R2. Results. Modern internal combustion engines cooling systems, including the direct driven coolant pump, are considered. The dependence of the engine heating temperature on the time of its operation with a mechanical drive of the pump and a drive from the electric motor was found. Analysis of cooling systems of the modern internal combustion engine with a direct drive of the coolant pump and with a controlled electric drive was carried out. Scientific novelty. Analysis of the cooling system of the car gasoline engine showed their dependence on the time of heating of the engine during cold start. It is established that engine with electrical driven pump has been found to reduce the heating time, compared to the engine with a mechanical drive of the pump, for one and a half minutes. This provides fuel savings 3 %, at the temperature of the pump motor switching on 130 °C. It is established that the use of the electric driven pump reduces its operation time by almost 50 %. Practical value. The functions of the coolant temperature dependence on the time of heating of the gasoline engine with the direct driven coolant pump and with the electrical driven pump are determined. This makes it possible to modernize the cooling system of small internal combustion engines.

Comparison of Electrical and Mechanical Water Pump Performance in Internal Combustion Engine

Experimental Research on Performance of Water Hydraulic Internal Gear Pump

Water Cooling System Design and Thermal Analysis for Electrical Vehicle Driving Motors

An Investigation in Performance of a Variable-Speed-Displacement Pump-Controlled Motor System

Comparing research on two different numerical models of electrostatically actuated valveless micropump

Analysis and Experimental Research on Efficiency Characteristics of a Deep-Sea Hydraulic Power Source

Study of Different Cooling Structures on the Thermal Status of an Internal Combustion Engine

MATHEMATICAL MODELING OF HEATING PROCESS THE COOLING SYSTEM OF THE INTERNAL COMBUSTION ENGINE USING WATER PUMP ELECTRIC DRIVE

Case Analysis on General Design of Engine Water Pump

Hydraulic performance prediction and optimization of an engine cooling water pump using computational fluid dynamic analysis

Comparison of Direct-Drive Permanent-Magnet Synchronous Motor and Permanent-Magnet Flux-Modulated Motor for Electric Vehicles

Comparisonstudies on flow measurement methods for cylinder water hole in diesel engine

Theoretical Analysis of a Water Hydraulic Internal Ball Gear Pump

Numerical Simulation and Analysis on Hydraulic Performance in Vertical Canned Motor Pump

Design Method of Water Jet Pump Towards High Cavitation Performances

Control Design of a Hydraulic Cooling Fan Drive for Off-Road Vehicle Diesel Engine with a Power Split Hydraulic Transmission

Investigation on the Energy Exchange Characteristics of the Regenerative Flow Pump in an Automobile Fuel System

Numerical and experimental study of variable speed automobile engine cooling water pump

Research on multi-objective optimization of automotive electronic water pump motor considering the factor of gap viscous loss

Energy Balance Analysis for a Canned Motor Pump Used for Heat Supply System

Investigation of the cavitation performance in an engine cooling water pump at different temperature