Abstract:For development of thin bioactive coatings on metal implants, a dense and uniform apatite layer was coated onto titanium (Ti) implants in situ by using a new biomimetic method, which is composed of apatite nucleation and growth steps in simulated body fluid (SBF). Analysis of the coatings by thin film X-ray diffraction and scanning electron microscopy-energy dispersive X-ray microanalysis (SEM-EMPA) before implantation showed that its characteristics were very similar to those of natural bone. The coated and uncoated rectangular plates were bilaterally implanted into the tibial proximal metaphyses of rabbits. After 6, 10 and 25 weeks post-implantation, the bone bonding and bone formation at the bone-implant interfaces were evaluated by a detachment test and undecalcified histological examination. Mechanical testing in tension showed that the failure load of apatite layer-coated Ti implants was significantly higher than that of uncoated control at each time period (all P < 0.001). Histologically, it was shown that bone was deposited directly onto the apatite coating without any intervening soft tissue, while in the paired controls, interpositional soft tissue was seen at the bone-implant interface. By SEM-EPMA, a uniform calcium- and phosphorus-rich layer was detected between the coated implants and bone, but not in uncoated controls at either earlier or later time periods. The results indicate that the apatite layer deposited on Ti in situ may significantly increase the bone bonding strength by providing a bioactive surface, which allows for an early bone apposition to the implant. In addition, the apatite layer-coated Ti produced by the biomimetic process may fulfil the requirements of favourable thin coatings and strong adhesion at the metal-coating interface.

Apatite formation on porous titanium by alkali and heat-treatment

A Comparative Study of in Vitro Apatite Deposition on Heat-, H(2)O(2)-, and NaOH-treated Titanium Surfaces.

Biomimetic Deposition of Apatite on Electrochemically Oxidized Titanium Substrates

Apatite deposition on thermally and anodically oxidized titanium surfaces in a simulated body fluid.

Graded apatite formation on surface of Porous titanium by simple chemistry

[Experimental Study of Fast Formation of Biomimetic Apatite Coatings on Pure Titanium Surface].

Enhancement of the Bioactivity of Alkali-Heat Treated Porous Titanium by Pre-Calcification

Study on Formation of Apatite Coating by Alkaline Solution and Heat Treatment on Porous Titanium

[Fast Formation of Biomimetic Apatite Coatings on Pure Porous Titanium Implant's Surface].

Apatite Layer-Coated Titanium for Use As Bone Bonding Implants

Preparation of Hierarchical Porous Structure on Ti Surface and Bioactivity

Longer-Term Mechanical And Biological Evaluation Of Titanium Alloy Coated With Apatite Layer

Study on Porous Titanium Biomedical Materials

Apatite Formation Induced by Alkaline Treatment on Titanium Alloy Substrate

Effect of heat-treatment atmosphere on the bond strength of apatite layer on Ti substrate

Formation of apatite on porous titanium in different supersaturated calcification solution

Bioactive Composite Coating on Titanium Implants for Hard Tissue Repair

Bioactive macroporous titanium surface layer on titanium substrate

Mechanism of apatite formation on pure titanium treated with alkaline solution

Hydrothermal treatment of Ti surface to enhance the formation of low crystalline hydroxyl carbonate apatite

Mechanical Properties and Bioactive Surface Modification Via Alkali-Heat Treatment of Porous Titanium for Biomedical Applications