Abstract:We report on the results of a comparative study in which the mechanical response of both fully dense and porous low-Îº dielectric thin films was evaluated using two different techniques: nanoindentation and the plane-strain bulge test. Stiffness values measured by nanoindentation are systematically higher than those obtained using the bulge test technique. The difference between the measurements is caused by the Si substrate, which adds significantly to the contact stiffness in the indentation measurements. Depending on the properties of the coatings, the effect can be as large as 20%, even if the indentation depth is less than 5% of the film thickness. After correction of the nanoindentation results for the substrate effect using existing models, good agreement is achieved between both techniques. The results further show that densification of porous material under the indenter does not affect stiffness measurements significantly. By contrast, nanoindentation hardness values of porous thin films are affected by both substrate and densification effects. It is possible to eliminate the effect of densification and to extract the yield stress of the film using a model for the indentation of porous materials proposed by the authors. After correcting for substrate and densification effects, the nanoindentation results are in close agreement with the bulge test measurements. The results of this comparative study validate the numerical models proposed by Chen and Vlassak for the substrate effect and by Chen et al. for the densification effect.

Nanomechanical Properties of Passivation Thin Films in Integrated Circuit

In Situ Nanoindentation Mechanical Property of Films by Atomic Force Microscope

A comparative micro-cantilever study of the mechanical behavior of silicon based passivation films

Measurement and Analysis on the Mechanical Properties of Silicon Carbide Film

Mechanical Properties of Silicon Carbonitride Thin Films

A Method To Extract The Intrinsic Mechanical Properties Of Soft Metallic Thin Films Based On Nanoindentation Continuous Stiffness Measurement Technique

Mechanical Properties Of Zirconia Thin Films Deposited By Filtered Cathodic Vacuum Arc

Nanohardness by Nanoindentation

Extraction Of Elastic Modulus And Hardness Of The Soft Metallic Films On Hard Substrates By Nanoindentation

Nanoindentation and Deformation Behaviors of Silicon Covered with Amorphous SiO2: a Molecular Dynamic Study

PREDICTIONS OF NANOHARDNESS AND ELASTIC MODULUS OF THIN FILM MATERIAL WITH THE QUASICONTINUUM METHOD

Preparation of Sion Film by Plasma Enhanced Chemical Vapor Deposition and Passivation on Si

Nanoindentation of Porous Bulk and Thin Films of LSCF

Investigation of PECVD SiC nano film

Evaluation of the Mechanical Properties of Thin Metal Films

Hardness measurements of thin films-determining the critical ratio of depth to thickness using FEM

The Mechanical Properties of Electroplated Cu Thin Films Measured by Means of the Bulge Test Technique

Nanomechanical Properties of Molecular Deposition Film

The Mechanical Properties and Resistivity of Au/NiCr/Ta Multi-Layered Films on Si-(111) Substrate

A novel approach to extracting hardness of copper/niobium (Cu/Nb) multilayer films by removing the substrate effect

Study of Mechanical Properties of PZT Piezoelectric Film by Nano-indentation Technique