Abstract:As a commonly reinforcing phase in wear-resistant materials, TiC is often added into wear-resistant materials to improve the wear resistance. The independently developed stepped molds with variable thicknesses were used to prepare the TiC-reinforced steels with the same composition though melt solidification processing to study the effect of the solidification rate on the particle size and wear performance. The effect of the hot rolling compression ratio on the particle size and wear performance was also studied. The length and aspect ratios of the particles in heat-treated TiC-reinforced steels with different billet thicknesses and rolling compression ratios were measured. With the increasing in the billet thickness and the decreasing in the rolling compression ratio, the length and aspect ratio of the particles increased in heat-treated TiC-reinforced steels, and the hardness decreased slightly. The three-body abrasive wear behavior of the TiC-reinforced steels was conducted using a standard dry sand rubber wheel wear testing procedure, and the modeling of the wear mechanism was established. The particle size is the main factor affecting wear resistance when the hardness of TiC-reinforced steels is similar. When the particles size is moderate, about 2–6 μm, the particle can break the sand tip and hinder the sand tip from sliding on the surface. In this manner, the mass loss decreased and the wear resistance improved. The large particles will be broken easily by the abrasive, and the small particles are removed easily by the abrasive in the wear process. So, the large and small particles cannot effectively prevent the damage of the abrasive to the matrix, and they have less of an effect on improving wear resistance.

Effect of TiC-particle Size on Sliding Wear of TiC Particulate Reinforced Alumina Composites

Wear Behaviour and Microstructural Changes of SiCw-Al Composite under Unlubricated Sliding Friction

Contributions of the Particulate Reinforcement to Dry Sliding Wear Resistance of Rapidly Solidified Al-Ti Alloys

The Influence of TiC-particle-size on the Fracture Toughness of Al2O3–30 Wt.%tic Composites

Effect of TiC Particle Size on the Toughness Characteristics of Al2O3–TiC Composites

Preparation of Ultra-Fine ATC Ceramics and Analysis of Its Dry-Sliding Wear Behavior

Preparation and Characterization of In Situ (TiC-TiB2)/Al-Cu-Mg-Si Composites with High Strength and Wear Resistance

Microstructure and Wear Behaviour of Ceramic Particles Strengthening Nial Based Composite

The Dry Sliding Wear Properties of Nano-Sized TiCp/Al-Cu Composites at Elevated Temperatures

Research On Wear Behavior Of Atc Cermet Material

Influence of TiC particle size on microstructural evolution and fracture mechanism of TiC/Al-Cu composites

Microstructure and Sliding Wear Behavior of PM Alloy Al10Ti after Thermal Exposure

Influence of TiC particle size on the load-independent hardness of Al2O3–TiC composites

Dry sliding friction and wear properties of B4C particulate-reinforced Al-5083 matrix composites

Tribological properties and microstructures of Al2O3-TiC-TiB2 reinforced composites

Tribological behavior of in-situ nanosized TiB2 particles reinforced AZ91 matrix composite

Effect of Ni content on the wear behavior of Al-Si-Cu-Mg-Ni/SiC particles composites

Investigation of microstructure and tribological performances of high-fraction TiC/graphene reinforced self-lubricating Al matrix composites

Effect of Solidification and Hot Rolling Processes on Wear Performance of TiC-Reinforced Wear-Resistant Steel

The Wear Behavior of the Laser Cladded Ti-Al-Si Composite Coatings on Ti-6Al-4V Alloy with Additional TiC

Friction and wear behaviors of Al 2 O 3 /TiC micro-nano-composite ceramic sliding against metals and hard materials