Abstract:Particle dispersion and deposition in man-made enclosed environments are closely related to the well-being of occupants. The present study developed a three-dimensional drift-flux model for particle movements in turbulent indoor airflows, and combined it into Eulerian approaches. To account for the process of particle deposition at solid boundaries, a semi-empirical deposition model was adopted in which the size-dependent deposition characteristics were well resolved. After validation against the experimental data in a scaled isothermal chamber and in a full-scale non-isothermal environmental chamber, the drift-flux model was used to investigate the deposition rates and human exposures to particles from two different sources with three typical ventilation systems: mixing ventilation (MV), displacement ventilation (DV), and under-floor air distribution (UFAD). For particles originating from the supply air, a V-shaped curve of the deposition velocity variation as a function of particle size was observed. The minimum deposition appeared at 0.1–0.5μm. For supermicron particles, the ventilation type and air exchange rate had an ignorable effect on the deposition rate. The movements of submicron particles were like tracer gases while the gravitational settling effect should be taken into account for particles larger than 2.5μm. The temporal increment of human exposure to a step-up particle release in the supply air was determined, among many factors, by the distance between the occupant and air outlet. The larger the particle size, the lower the human exposure. For particles released from an internal heat source, the concentration stratification of small particles (diameter <10μm) in the vertical direction appeared with DV and UFAD, and it was found the advantageous principle for gaseous pollutants that a relatively less-polluted occupied zone existed in DV and UFAD was also applicable to small particles.

Experimental Study on Deposition of Aerosol Particles in Ductwork

Experimental Study on Deposition Velocities of Aerosol Particles in Rectangular Duct

An experimental approach to measure particle deposition in large circular ventilation ducts

Study on the deposition characteristics of fine particles at local components in air conditioning ventilation ducts

Study on particle deposition in ventilation ducts

An Experimental Study on Short-Time Particle Resuspension from Inner Surfaces of Straight Ventilation Ducts

Particle deposition in ventilation ducts: A review

Numerical analysis of particle deposition in ventilation duct

Experimental Study on Distribution and Transport of Indoor Aerosol Particles

Experimental research and modeling of particle deposition in ventilation ducts

Kinematic Characteristics and Thermophoretic Deposition of Inhalable Particles in Temperature Gradient Field

Effect of Particle Spatial Distribution on Particle Deposition in Ventilation Rooms

Modeling particle dispersion and deposition in indoor environments

Experimental Study of Solid Particle Deposition in 90° Ventilated Bends of Rectangular Cross Section with Turbulent Flow

CFD simulation of particle deposition in a horizontal turbulent duct flow

Effect of Ventilation Duct As a Particle Filter

How Particle Resuspension from Inner Surfaces of Ventilation Ducts Affects Indoor Air Quality-A Modeling Analysis

Analytical Prediction Model for Particle Deposition in Ventilation Ducts

Simulation of Particles Diffusion Characteristics in the Ventilation Duct of the Air Conditioning System

Particles depositions onto non-smooth surfaces of ventilation ducts

Deposition Rates on Smooth Surfaces and Coagulation of Aerosol Particles Inside a Test Chamber