Abstract:Particle dispersion and deposition in man-made enclosed environments are closely related to the well-being of occupants. The present study developed a three-dimensional drift-flux model for particle movements in turbulent indoor airflows, and combined it into Eulerian approaches. To account for the process of particle deposition at solid boundaries, a semi-empirical deposition model was adopted in which the size-dependent deposition characteristics were well resolved. After validation against the experimental data in a scaled isothermal chamber and in a full-scale non-isothermal environmental chamber, the drift-flux model was used to investigate the deposition rates and human exposures to particles from two different sources with three typical ventilation systems: mixing ventilation (MV), displacement ventilation (DV), and under-floor air distribution (UFAD). For particles originating from the supply air, a V-shaped curve of the deposition velocity variation as a function of particle size was observed. The minimum deposition appeared at 0.1–0.5μm. For supermicron particles, the ventilation type and air exchange rate had an ignorable effect on the deposition rate. The movements of submicron particles were like tracer gases while the gravitational settling effect should be taken into account for particles larger than 2.5μm. The temporal increment of human exposure to a step-up particle release in the supply air was determined, among many factors, by the distance between the occupant and air outlet. The larger the particle size, the lower the human exposure. For particles released from an internal heat source, the concentration stratification of small particles (diameter <10μm) in the vertical direction appeared with DV and UFAD, and it was found the advantageous principle for gaseous pollutants that a relatively less-polluted occupied zone existed in DV and UFAD was also applicable to small particles.

How Particle Resuspension from Inner Surfaces of Ventilation Ducts Affects Indoor Air Quality-A Modeling Analysis

Effect of particle resuspension from ventilation duct on indoor environment

Particulate Pollution in Ventilated Space: Analysis of Influencing Factors.

Modeling particle fate in ventilation system—Part I: Model development

An Experimental Study on Short-Time Particle Resuspension from Inner Surfaces of Straight Ventilation Ducts

A Particle Resuspension Model in Ventilation Ducts

Experimental research and modeling of particle deposition in ventilation ducts

Modeling particle dispersion and deposition in indoor environments

Effect of Ventilation Duct As a Particle Filter

Study on the deposition characteristics of fine particles at local components in air conditioning ventilation ducts

Analysis of Factors Influencing Indoor Particle Concentration Using the Lumped Parameter Model

ANALYSIS AND CALCULATION OF THE POLY-DISPERSE PARTICLES RESUSPENSION PROCESS IN A VENTILATION AND AIR-CONDITIONING SYSTEM

Study On The Characteristics Of Indoor Inhalable Particle Distribution In Underfloor Air Supply System

Experimental study on resuspension characteristics of inhalable particles in under floor air distribution system

Predicting Indoor Deposited Particle Resuspension with a New Probabilistic Model Based on Markov Chain and Turbulent Burst

Effect of Ventilation and Filtration on Submicrometer Particles in an Indoor Environment.

Particle deposition in ventilation ducts: A review

An experiment and numerical study of resuspension of fungal spore particles from HVAC ducts.

Control Strategies for Sub-Micrometer Particles Indoors: Model Study of Air Filtration and Ventilation.

Experimental Study on Deposition of Aerosol Particles in Ductwork

Modeling of Ultrafine Particle Dispersion in Indoor Environments with an Improved Drift Flux Model