Abstract:Submerged floating tunnel (SFT) is a new type of cable-supported structure system for strait crossing. Once the local anchor-cable suddenly fails, it will inevitably cause evident vibration and internal force redistributions of the structure. In order to study the dynamic responses and mechanical behaviors of the SFT subjected to abrupt anchor-cable breakage, a model test is conducted by a set of sensors installed on SFT for cable force, tube displacement and strain measurements. The transient dynamic signals following cable failure are tested and analyzed. Dynamic amplification factor (DAF) and dynamic coefficient (DC) are respectively used to evaluate the impact effect from the cable failure. Meanwhile, finite element simulations are also performed within ABAQUS. The establishments of the finished state of SFT before cable breakage and the dynamic cable failure process are presented both in the model test and FE model. Comparisons between the FE predicted values and the experimental results show a good agreement. On this basis, some influence factors are discussed in different cases of the cable-loss positions and the cable forces of ruptured cable, etc. The results show that the finished state of SFT under dead load (tube redundant buoyancy) after cable-force optimizations is more reasonable than that directly applying dead load without any cable-force adjustments, with more uniform cable force distribution and smaller tube deformation. Although the SFT suffers strong oscillations after sudden cable-breakage incident, no progressive collapse occurs when the safety margin of the rest structure is sufficient. The dynamic effect on remaining cable members due to sudden cable failure can be evaluated by DC method. A DC value of 1.5 is recommended to ensure the safety of SFT anchor-cables. When cable failure happens at the mid span of the tunnel, the deformation of SFT tube is most critical.

Test and full-process simulation analysis of the full-scale model of cable support tower segment

An experimental study on large-span spatial cable-truss tensile structure model

Model Experiment on the Static Behaviors of a Crescent-Shaped Cable-Truss Canopy Structure

The model experimental research on rib-patterned large-span spatial cable-truss tensile structure with annular plane

STUDY ON THE FULL SCALE SEGMENTAL MODEL OF A TOWER OF A CABLE STAYED BRIDGE OF THE SECOND YANGIZE RIVER BRIDGE IN NANJING

The Full-scale Model Test and Spatial Analysis for the Segment of Cable Pylon of Cable-stayed Bridge

Simulation Analysis of Girder Transport Process on the Box Girder of Hangzhou Bay Bridge

Experimental study on cable-truss reinforced structure system under heavy load

Strength Check and Stress Test for Hoisting Mechanism of the 1300t Box-type Derrick Floating Crane

Simulation of cantilever-casting construction of prestressed concrete cable-stayed bridge

The Test and Spatial Analysis for the Full Scale Segment Model of the Cable Pylon of Poyanghukou Bridge

Finite element analysis and test study of dynamic behavior of a cable-stayed bridge

Full-Scale Segment Model Test and Performance Improvement Scheme of Cable-Pylon Anchorage Zone for Cable-Stayed Bridge

Cable force adjustment and post-adjusting nonlinear analysis of a cable-stayed bridge based on ANSYS

Spatial Analysis of Self-anchored Suspension Bridge and Its Experimental Study

Segmental Intelligent Model Test of Box Girder Bridge Strengthened By a Cable-Stayed System by Mathematical Calculation

Study on Typical Dynamic Characteristics of a Long-span Prestressed Concrete Cable-stayed Bridge

Test on the composite joint section between steel box girder and concrete tower of a cable-stayed bridge

Simulating analysis of cantilever casting of prestressed concrete bridge

Mechanical Behaviors and Experimental Study of Submerged Floating Tunnel Subjected to Local Anchor-Cable Failure

Assessment of cable tension condition based on optimum cable tension of cable-stayed bridge