Abstract:This article proposes a novel wideband commongate (CG) common-source (CS) low-noise amplifier (LNA) with active feedforward for simultaneous current and noise reduction. By employing an active feedforward stage in the main path, the current dissipation and the thermal noise are effectively suppressed, while the noise and distortion cancelation properties of CG-CS topology are preserved. Moreover, no extra noise is introduced since the additional g(m)-boost amplifier follows the same noise-canceling (NC) principle as the CG amplifier, and its noise can be fully canceled at the output theoretically. Thus, the proposed LNA benefits from the g(m) -boosting and NC technique simultaneously to obtain a good tradeoff between gain, noise figure (NF), and power consumption. Fabricated in standard 40-nm CMOS technology, the measured results show the proposed LNA exhibits a peak gain of 17 dB, NF of 3.5-5.5 dB from 1 to 11 GHz and an IIP3 of -2.8 dBm at 6 GHz. It consumes 9 mW from a 1.2-V supply and occupies a very compact die area of 0.061 mm(2).

A 0.4-V Low Noise Amplifier Using Forward Body Bias Technology for 5 GHz Application

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A Low-Voltage and Low-Power CMOS LNA Using Forward-Body-Bias NMOS at 5GHz

A Highly Linear 2.4GHz Low Noise Amplifier

A 11.2 Mw 48–62 GHz Low Noise Amplifier in 65 Nm CMOS Technology

Ultralow Power E-Band Low-Noise Amplifier with Three-Stacked Current-Sharing Amplification Stages in 28-Nm CMOS

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A 0.061-Mm² 1–11-Ghz Noise-Canceling Low-Noise Amplifier Employing Active Feedforward with Simultaneous Current and Noise Reduction

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

A fully integrated 0.18-/spl mu/m CMOS low noise amplifier for 2.4-GHz applications

A Fully Integrated 0.18-Mu M Cmos Low Noise Amplifier for 2.4-Ghz Applications

A High Gain Fully Integrated CMOS LNA for WLAN and Bluetooth Application

A Novel CMOS Low-Noise Amplifier Design for 3.1- to 10.6-Ghz Ultra-Wide-band Wireless Receivers

A 2.8–10-GHz CMOS Current Reuse Cascaded Linearity Improving Ultra-Wideband Low-Noise Amplifier

Ultra low power inductorless low noise amplifier: Comparison of FDSOI technologies

A 0.0081mm2 0.15–5.9-Ghz Low Noise Amplifier with Noise Cancelling and Current Reuse Techniques

Design of a Low Voltage Neutralized CMOS Differential Low Noise Amplifier

A Low Power High Gain UWB LNA in 0.18-Μm CMOS

A Fully Integrated Dual‐band Low‐noise Amplifier for Bluetooth and Wireless LAN Applications

A CMOS Wide-Band Low-Noise Amplifier with Balun-Based Noise-Canceling Technique

A 2.4 GHz Gain-controlled CMOS Low Noise Amplifier