Abstract:The structural degradation of steel bars in reinforced concrete (RC) beams due to the adverse effects of corrosion is a leading cause of the increasing likelihood of RC beam failure. Through the previous researches, it can be seen that the mechanical properties , crack initiation threshold, fracture threshold, and fatigue life of steel bars are closely linked to their corrosion profiles and the corrosion levels. However, due to limitations of testing equipment, accurately identifying the corrosion profiles of corroded steel bars has proven challenging. Therefore, at present, only predictive models have been established using regression analysis to investigate the mechanical properties and fatigue performance of corroded steel bars, and corresponding theoretical models for their assessment have not yet been developed. In order to establish corresponding theoretical models for precise evaluation of the mechanical properties and fatigue performance of corroded steel bars. Firstly, an artificial accelerated corrosion test was conducted on steel bars to assess their mechanical properties and fatigue performance. Different levels of corrosion were analyzed to understand the associated failure modes and to determine the cracking threshold and fracture threshold of the corroded steel bars.Secondly, a 3D scanner was employed to capture the surface profiles of steel bars with varying degrees of corrosion. Based on the data gathered from these scans, predictive models were developed to assess the mechanical properties and fatigue performance of corroded steel bars. Furthermore, corresponding finite element models were established to further investigate the impact of steel wire corrosion on the remaining service life of the bars. The results of our research demonstrate the effectiveness of the load-bearing capacity assessment proposed in this paper, as it accurately predicts the load-bearing capacity of corroded wires and aligns well with experimental findings. Additionally, our study revealed that the cracking threshold value for all types of steel bars exceeded 6.2 MPa·m 1/2 , and the fracture threshold intensity factor decreased as steel bars experienced more severe corrosion.

Study on Evaluation Method of Corroded Reinforcing Steel

Probability-Based Performance Degradation Model and Constitutive Model for the Buckling Behavior of Corroded Steel Bars

Evaluation of corrosion morphology on mechanical properties of reinforcing steel bars using numerical simulation and simplified analytical model

Mechanical Performance of Corroded Steel Bars in Concrete

Bond Strength Evaluation of Corroded Steel Bars Via the Surface Crack Width Induced by Reinforcement Corrosion

State-of-the-art Review on the Bond Properties of Corroded Reinforcing Steel Bar

Study of Wiring Method on Accelerated Corrosion of Steel Bars in Concrete

Applicability Study on Accelerated Corrosion Methods of Steel Bars in Concrete Structure

Test study on bond behavior of corroded steel bars and concrete

Study on Experimental Method and Morphology of Accelerated Non-Uniform Corrosion of Steel Bars

Experimental Study of the Modulus of Steel Corrosion in a Concrete Port

Performance of Corroded Reinforced Concrete Columns under the Action of Eccentric Loads

Performance of Reinforced Concrete Beams Corroded under Sustained Service Loads: A Comparative Study of Two Accelerated Corrosion Techniques

Comprehensive study on corrosion induced structural deterioration of steel bars in reinforced concrete beams

Evaluation of Corrosion Characteristics and Corrosion Effects on the Mechanical Properties of Reinforcing Steel Bars Based on Three-Dimensional Scanning

Performance Degradation of Steel Rebar Considering Corrosion Spatial Variability in Concrete

Study on Degradation Regularity of Bearing Capacity of RC Beams under Corrosive Conditions

THE CORROSION MONITORING USING RESISTANCE-PROBE METHOD IN THE CEMENT MOTAR AND COMPARING WITH ELECTROCHEMISTRY-PROBE METHOD

Study On Modulus Of Rust Applied In Steel Corrosion Induced Concrete Cracking Model

Tensile Behaviour of Pitting Corroded Steel Bars: Laboratory Investigation and Probabilistic-Based Analysis

Tensile and fatigue behavior of corroded rebars