Abstract:Sample injection is a critical step in a capillary electrophoresis (CE) analysis. Electrokinetic injection is the simplest approach and is often selected for implementation in portable CE instruments. However, in order to minimize the effect of sample matrix upon the results of a CE analysis, hydrodynamic injection is preferred. Although portable CE instruments with hydrodynamic injection have been reported, injection has always been performed at the grounded end of the capillary. This simplifies fluidic handling but limits coupling with electrochemical detectors and electrospray ionization-mass spectrometry (ESI-MS). We demonstrated previously that injection at the high-voltage (HV) end of the capillary could be performed using an HV-compatible rotary injection valve (fixed-volume injection). However, the mismatch between the bore sizes of the channels on the rotor-stator valve and the separation capillary caused peak tailing and undesired mixing, impairing analytical performance. In this work, we present an HV-compatible hydrodynamic injection approach that overcomes the issues associated with the fixed-volume injection approach reported previously. The performance of the CE instrument was demonstrated by analyzing a mixture of 13 amino acids by CE coupled to laser-induced fluorescence, which showed relative standard deviations for peak area and migration time below 5% and 1%, respectively, for triplicate analysis. Additionally, replicate measurements of a mixture of amino acids, peptides, nucleobases, and nucleosides by CE coupled to electrospray ionization-mass spectrometry (CE-ESI-MS) were performed to evaluate peak tailing, and results were similar to those obtained with a commercial CE-ESI-MS setup.

Improved hydrostatic pressure sample injection by tilting the microchip towards the disposable miniaturized CE device.

Double-cross hydrostatic pressure sample injection for chip CE: variable sample plug volume and minimum number of electrodes.

Further Improvement of Hydrostatic Pressure Sample Injection for Microchip Electrophoresis

Flow Stabilizer on a Syringe Tip for Hand-Powered Microfluidic Sample Injection

Negative Pressure Pinched Sample Injection for Microchip-Based Electrophoresis.

Improvements on the electrokinetic injection technique for microfluidic chips

A SANDWICH-INJECTION METHOD FOR MICROCHIP ELECTROPHORESIS

A Pressure-Driven Capillary Electrophoretic System with Injection Valve Sampling.

Numerical analysis of an electrokinetic double-focusing injection technique for microchip CE.

Elimination of suction effect in interfacing microchip electrophoresis with inductively coupled plasma mass spectrometry using porous monolithic plugs.

Improving hydrodynamic injection in capillary electrophoresis by using the integral of pressure

In-Channel Modification of Biosensor Electrodes Integrated on A Polycarbonate Microfluidic Chip for Micro Flow-Injection Amperometric Determination of Glucose

Acupuncture injection for field amplified sample stacking and glass microchip-based capillary gel electrophoresis

Microfabrication of Integrated Capillary Electrophoresis Chips and On-chip Sample Injection and Separation

A microfluidic system for introduction of nanolitre sample in inductively coupled plasma mass spectrometry using electrokinetic flow combined with hydrodynamic flow

A flexible sample introduction method for polymer microfluidic chips using a push/pull pressure pump.

An Automated Electrokinetic Continuous Sample Introduction System for Microfluidic Chip-Based Capillary Electrophoresis

High-throughput Droplet Analysis and Multiplex DNA Detection in the Microfluidic Platform Equipped with a Robust Sample-Introduction Technique.

A hydrodynamic injection approach for capillary electrophoresis using rotor-stator valves

A Microchip Device to Enhance Free Flow Electrophoresis Using Controllable Pinched Sample Injections

A gravity driven micro flow injection wetting film extraction system on a polycarbonate chip.