Abstract:This paper investigates the pull-in dynamics of single-sided and double-sided parallel-plate (SSPP and DSPP) structures employed in MEMS devices for acceleration measurement. A lumped electromechanical model considering a variable damping coefficient and external acceleration is developed for studying their pull-in dynamical behavior. The critical pull-in displacement and pull-in voltage for both parallel-plate structures operated with external acceleration are derived based on the static and dynamical analysis of the proposed model, which are in good agreement with the experimental results. The derived closed-form solutions are shown to be capable of predicting the pull-in behavior of both parallel-plate structures in an overdamped system. Two MEMS parallel-plate structures exhibit distinct pull-in characteristics due to their distinct configurations. The commonly used SSPP structure for MEMS devices is shown to have a relatively linear response to the external acceleration in terms of the critical pull-in displacement and pull-in voltage. However, the DSPP structure exhibits much larger yet nonlinear sensitivity of both the critical pull-in displacement and the critical pull-in voltage to a small range of external acceleration, which has the potential of developing high-sensitivity accelerometers whenever the sensitivity nonlinearity is compensated. Moreover, the effects of pressure are characterized for both DSPP and SSPP devices, which affects the difference between the critical static and dynamic pull-in voltages. The SSPP structure is shown to have the critical pull-in voltage proportional to the logarithmic magnitude of the pressure, while that of the DSPP structure do not vary linearly with respect to the logarithmic magnitude of the pressure.

Pull-in Characterization of Doubly-Clamped Composite Beams

Analytical model of electrostatic fixed-fixed microbeam for pull-in voltage

Measurement Of Material Properties Of Individual Layers For Composite Films By A Pull-In Method

Pull-In Dynamics of Two MEMS Parallel-Plate Structures for Acceleration Measurement

An in-situ technique for measuring young's modulus and residual stress of each layer for multi-layer film

An Electrostatic Actuated Microelectromechanical In-Situ Extracting Method for Material Property of Multi-Layer Film

Characterization of Extensional Multi-Layer Microbeams in Pull-In Phenomenon and Vibrations

In Situ Measurement of Elastic Modulus of Individual Layers for Composite Thin Films by MEMS Test Structures

An Analytical Model for Pull-in Voltage of Clamped–clamped Multilayer Beams

Modeling Techniques for Active Shape and Vibration Control of Macro-Fiber Composite Laminated Structures

An analytical model considering size effect for calculating the pull-in voltage of electrostatically actuated micro curled cantilever beams

Pre-use Interfacial Shear Strength Prediction for Fiber-Reinforced Thermosetting Composites Based on Stress-Impedance Effect of Ferromagnetic Microwires

New Methods for Measuring Mechanical Properties of Thin Films in Micromachining: Beam Pull-in Voltage (VPI) Method and Long Beam Deflection (LBD) Method

Computational modelling of postbuckling behavior of composite T-stiffened panels with different bonding methods

RF-MEMS beam components : FEM modelling and experimental identification of pull-in in presence of residual stress

A simple analytical method for residual stress measurement on suspended MEM structures using surface profilometry

Measurement of Material Properties for Polysilicon Thin Films by an Electrostatic Force Method

Analysis of Impact of Bottom Electrode Position on Dynamic Pull-In Parameters of Microcantilevers

Analytical closed-form solutions for size-dependent static pull-in behavior in electrostatic micro-actuators via Fredholm integral equation

M-Test Method For Measuring Mechanical Property Of Multi-Layer In Mems

Pull-in voltage analysis for an electrostatically actuated extensional microbeam with large deflection