Abstract:This study presents a colloidal synthesis method to produce thermoelectric Cu3SbSe4 nanocrystals with high yield. Pb doping is employed to increase carrier concentration and effective mass, confirmed by experimental studies and theoretical calculations. Additionally, lattice distortions and other intriguing nanostructures are found to significantly reduce thermal conductivity. Consequently, the thermoelectric figure of merit zT is greatly enhanced. Developing cost‐effective and high‐performance thermoelectric (TE) materials to assemble efficient TE devices presents a multitude of challenges and opportunities. Cu3SbSe4 is a promising p‐type TE material based on relatively earth abundant elements. However, the challenge lies in its poor electrical conductivity. Herein, an efficient and scalable solution‐based approach is developed to synthesize high‐quality Cu3SbSe4 nanocrystals doped with Pb at the Sb site. After ligand displacement and annealing treatments, the dried powders are consolidated into dense pellets, and their TE properties are investigated. Pb doping effectively increases the charge carrier concentration, resulting in a significant increase in electrical conductivity, while the Seebeck coefficients remain consistently high. The calculated band structure shows that Pb doping induces band convergence, thereby increasing the effective mass. Furthermore, the large ionic radius of Pb2+ results in the generation of additional point and plane defects and interphases, dramatically enhancing phonon scattering, which significantly decreases the lattice thermal conductivity at high temperatures. Overall, a maximum figure of merit (zTmax) ≈ 0.85 at 653 K is obtained in Cu3Sb0.97Pb0.03Se4. This represents a 1.6‐fold increase compared to the undoped sample and exceeds most doped Cu3SbSe4‐based materials produced by solid‐state, demonstrating advantages of versatility and cost‐effectiveness using a solution‐based technology.

Fabrication and Property of High-Performance Ag-Pb-Sb-Te System Semiconducting Thermoelectric Materials

Enhanced thermoelectric performance of n -type PbTe bulk materials fabricated by semisolid powder processing

High-performance Ag0.8Pb18+xSbTe20 Thermoelectric Bulk Materials Fabricated by Mechanical Alloying and Spark Plasma Sintering

Microstructure and thermoelectric properties of porous Bi 2 Te 2.85 Se 0.15 bulk materials fabricated by semisolid powder processing

AgPbSbTe Thermoelectric Materials Fabricated by Mechanical Alloying and Spark Plasma Sintering(SPS)

Thermoelectric Performance of AgPb X SbTe 20 ( X = 17 to 23) Bulk Materials Derived from Large-Particle Raw Materials

Nanostructure and High Thermoelectric Performance in Nonstoichiometric AgPbSbTe Compounds: the Role of Ag

Composition Optimization of P-Type AgSn M SbTe M +2 Thermoelectric Materials Synthesized by Mechanical Alloying and Spark Plasma Sintering

Mid-temperature Thermoelectric Performance of Zone-Melted Sb2(Te,Se)3 Alloys Near Phase Transition Boundary

Powder Metallurgic Synthesis of Mid-Temperature Lead-Free Agsn18sbte20 Thermoelectric Materials and Processing Influence on Thermoelectric Performance

Preparation of AgxPbmSbTe2+m-Based Thermoelectric Materials by MA-SPS Method and Evaluation of Their Thermoelectric Properties

Thermoelectric enhancement at low temperature in nonstoichiometric lead-telluride compounds

High Performance Thermoelectrics from Earth-Abundant Materials: Enhanced Figure of Merit in Pbs Through Nanostructuring Grain Size

High-Performance SnTe Thermoelectric Materials Enabled by the Synergy of Band Convergence and Phonon Scattering

Fine-grained Lead-Free P-Type AgSn 4 SbTe 6 Thermoelectric Materials Synthesized by Mechanical Alloying and Spark Plasma Sintering

Band convergence and nanostructure modulations lead to high thermoelectric performance in SnPb0.04Te-y% AgSbTe2

Comparison of Thermoelectric Performance of AgPbxSbTe20 (x=20–22.5) Polycrystals Fabricated by Different Methods

Fast Preparation of AgxPb20SbTe20 (x = 0.5–3) Component with High Thermoelectric Performance

Superior thermoelectric performance in PbTe-PbS pseudo-binary: extremely low thermal conductivity and modulated carrier concentration

Band Engineering Through Pb‐Doping of Nanocrystal Building Blocks to Enhance Thermoelectric Performance in Cu3SbSe4

A Combinatorial Approach to Microstructure and Thermopower of Bulk Thermoelectric Materials: the Pseudo-Ternary PbTe–Ag2Te–Sb2Te3 System