Abstract:Insufficient durability still restricts the large-scale commercialization of fuel cells, rapid degradation of catalyst is considered to be the main reason, while support also plays an important role.In this study, the cyclic potential scanning with varies harshness to the catalysts are performed firstly. The membrane electrode assemblies (MEAs) are assembled to stack to perform the accelerate durability test (ADT) under New European Driving Cycle (NEDC) for 1000 h. The results show that, the durability of self-made catalysts is better than the commercial, and the voltage decay rate of commercial-MEA-Stack (35 μV h−1) is significantly higher than the self-made-MEA-Stack (5 μV h−1). Before and after the durability test, the charge and mass transfer impedance of S-MEA-Stack changes little, while that of C-MEA-Stack increases. Post-characterizations show that the self-made catalysts have better stability. In conclusion, the catalyst layer binding network based on mesoporous carbon has a more stable structure, which ensures the effective gas transport, while the high specific surface area structure is conducive to uniform distribution and stability of ionomers. Pt nanoparticles in mesoporous carbon can avoid the agglomeration and sintering, and the poisoning effect of sulfonate, thus improves the durability of the catalyst layer.

Durability Study of Double Catalytic Layer Anode for Direct Methanol Fuel Cell

Highly Active Nanoporous Pt-based Alloy As Anode and Cathode Catalyst for Direct Methanol Fuel Cells

Test on the Degradation of Direct Methanol Fuel Cell

Research Progress of Anode Catalysts for Direct Methanol Fuel Cell

Enhancing the life of direct methanol fuel cell

A Study of the Direct Dimethyl Ether Fuel Cell Using Alkaline Anolyte

Performance Degradation of A Direct Borohydride Fuel Cell

A Study on Performance Stability of the Passive Direct Borohydride Fuel Cell

Anode Sub-Layer in Membrane Electrode Assembly of DMFC

Preparation and Simulation of an Additional Catalyst Layer for Direct Methanol Fuel Cell

Improvement of Direct Methanol Fuel Cell Performance by Modifying Catalyst Coated Membrane Structure

Progress in Anode Catalysts and Preparation Techniques for Direct Methanol Fuel Cells

Recent Progress in Anode Catalysts of Direct Methanol Fuel Cells

Quantification and evolution on degradation mechanisms of proton exchange membrane fuel cell catalyst layer under dynamic testing conditions

Progress in Research on Cathodic Catalysts for Direct Methanol Fuel Cells

Quantification on Degradation Mechanisms of Polymer Exchange Membrane Fuel Cell Cathode Catalyst Layers During Bus and Stationary Durability Test Protocols

Study of Complete Methanol Depletion in Direct Methanol Fuel Cells

The function of microporous layers and the interaction between the anode and cathode in DMFCs. Part I: The double roles of microporous layers in DMFCs

Study on durability of proton exchange membrane fuel cell stack based on mesoporous carbon supported platinum catalysts under dynamic cycles conditions

Durability degradation mechanism and consistency analysis for proton exchange membrane fuel cell stack

An exploration of the solution of direct methanol fuel cell cost effectiveness