Abstract:The shift of the emission band to longer wavelength (yellow-orange) of the Ba2MgSi2−xAlxO7: 0.1Eu2+ phosphor under the 350–450nm excitation range has been achieved by adding the codoping element (Mn2+) in the host. The single-host silicate phosphor for WLED, Ba2MgSi2−xAlxO7: 0.1Eu2+, 0.1Mn2+ was prepared by high-temperature solid-state reaction. It was found experimentally that, its three-color emission peaks are situated at 623, 501 and 438nm, respectively, under excitation of 350–450nm irradiation. The emission peaks at 438 and 501nm originate from the transition 5d to 4f of Eu2+ ions that occupy the two Ba2+ sites in the crystal of Ba2MgSi2−x AlxO7, while the 623nm emission is attributed to the energy transfer from Eu2+ ions to Mn2+ ions. The white light can be obtained by mixing the three emission colors of blue (438nm), green (501nm) and red (623nm) in the single host. When the concentrations of the Al3+, Eu2+ and Mn2+ ions were 0.4, 0.1 and 0.1mol, respectively, the sample presented intense white emission. The addition of Al ion to the host leads to a substantial change of intensity ratio between blue and green emissions. White light could be obtained by combining this phosphor with 405nm light-emitting diodes. The near-ultraviolet GaN-based Ba2MgSi1.7 Al0.3O7: 0.1Eu2+, 0.1Mn2+ LED achieves good color rendering of over 85.

Luminescent Properties of BaMgAl10O17: Eu2+ Phosphors Coated with Y2SiO5

Luminescence Properties of Yb2+ Doped NaBaPO4 Phosphate Crystals

Synthesis and luminous characteristics of Ba2MgSi2-xAlxO7: 0.1Eu2+, 0.1Mn2+ phosphor for WLED

BaMgAl10O17:Eu2+ Mn2+ Blue-Green Phosphor for White Light Emitting Diodes

Luminescent properties of SrMgAl10 O17∶Eu2+,Mn2+ high-efficiency phosphor prepared via the sol-gel combustion method

Luminescence of Ba0.85MgAl10O16.94 : EU0.092+ with different fluxes

Luminescence of Bax−0.05MgAl10O16+x: Eu2+0.05 with Different Ba2+ Content

Luminescence of Ba 0.85 MgAl 10 O 16.94 :Eu 2+ 0.09 with Different Fluxes

Luminescence of Ba0.85MgAl10O16.94:Eu 0.09 2+ with different fluxes

Photoluminescence Studies of Eu2+-Yb3+ Co-Doped BaMgAl10O17 Phosphor Synthesized by the Combustion Method

Synthesis, structure, and luminescence properties of SrSiAl<sub>2</sub>O<sub>3</sub>N<sub>2</sub>:Eu<sup>2+</sup> phosphors for light-emitting devices and field emission displays

Luminescent Properties of the BaMgAl10O17:Eu2+,M3+ (M = Nd, Er) Phosphor in the VUV Region

Microstructure and Luminescence of Surface-Coated Nano-Bamgal10o17:Eu2+ Blue Phosphor

Luminescent properties of long afterglow MAl2Si2O8:Eu2+, Dy2+ (M=Ca, Sr, Ba) photoluminescent materials

Luminescence Properties And Energy Transfer Of Ce3+,Tb3+-Coactivated-Sialon Phosphors

Cathodoluminescence Properties of Ba3Si6O9N4:Eu2+ Phosphors

Preparation and Luminescent Properties of BAM Blue Phosphor Forpdp and CCFL

Preperation and Photoluminescent Properties of Ca2AlSi3O2N5:Sm3+ Phosphor

Enhancing the Emission Intensity and Decreasing the Full Widths at Half Maximum of Ba3Si6O12N2:Eu(2+) by Mg(2+) Doping.

Energy Transfer in BaMgAl_(10)O_(17):(Eu~(2+),Mn~(2+) Phosphor

Synthesis and Characterization of BaMgAl10O17:Eu Phosphors Derived by Sol–gel Processing