Abstract:The shift of the emission band to longer wavelength (yellow-orange) of the Ba2MgSi2−xAlxO7: 0.1Eu2+ phosphor under the 350–450nm excitation range has been achieved by adding the codoping element (Mn2+) in the host. The single-host silicate phosphor for WLED, Ba2MgSi2−xAlxO7: 0.1Eu2+, 0.1Mn2+ was prepared by high-temperature solid-state reaction. It was found experimentally that, its three-color emission peaks are situated at 623, 501 and 438nm, respectively, under excitation of 350–450nm irradiation. The emission peaks at 438 and 501nm originate from the transition 5d to 4f of Eu2+ ions that occupy the two Ba2+ sites in the crystal of Ba2MgSi2−x AlxO7, while the 623nm emission is attributed to the energy transfer from Eu2+ ions to Mn2+ ions. The white light can be obtained by mixing the three emission colors of blue (438nm), green (501nm) and red (623nm) in the single host. When the concentrations of the Al3+, Eu2+ and Mn2+ ions were 0.4, 0.1 and 0.1mol, respectively, the sample presented intense white emission. The addition of Al ion to the host leads to a substantial change of intensity ratio between blue and green emissions. White light could be obtained by combining this phosphor with 405nm light-emitting diodes. The near-ultraviolet GaN-based Ba2MgSi1.7 Al0.3O7: 0.1Eu2+, 0.1Mn2+ LED achieves good color rendering of over 85.

Luminescence of Ba0.85MgAl10O16.94 : EU0.092+ with different fluxes

Luminescence of Ba0.85MgAl10O16.94:Eu 0.09 2+ with different fluxes

Luminescence of Ba 0.85 MgAl 10 O 16.94 :Eu 2+ 0.09 with Different Fluxes

Luminescence of Bax−0.05MgAl10O16+x: Eu2+0.05 with Different Ba2+ Content

Preparation and Luminescent Properties of BAM Blue Phosphor Forpdp and CCFL

BaMgAl10O17:Eu2+ Mn2+ Blue-Green Phosphor for White Light Emitting Diodes

Synthesis and luminous characteristics of Ba2MgSi2-xAlxO7: 0.1Eu2+, 0.1Mn2+ phosphor for WLED

Photoluminescence Properties of BaMgAl10O17:Eu2+ Phosphor Prepared by the Flux Method

Luminescence and Morphology of BaMgAl10O17:Eu2+ Phosphors Prepared from Different Phases of Al2O3

Luminescent properties of SrMgAl10 O17∶Eu2+,Mn2+ high-efficiency phosphor prepared via the sol-gel combustion method

Luminescent Properties of the BaMgAl10O17:Eu2+,M3+ (M = Nd, Er) Phosphor in the VUV Region

Color Tunable Ba0.79Al10.9O17.14:xEu Phosphor Prepared in Air Via Valence State Control

Luminescence properties of Eu 2+ doped BaAl 2 Si 2 O 8 phosphor for white LEDs

Energy Transfer in BaMgAl_(10)O_(17):(Eu~(2+),Mn~(2+) Phosphor

The Luminescence of Eu3+ Activated Ba2mg(Bo3)(2) Phosphors

Enhancing the Emission Intensity and Decreasing the Full Widths at Half Maximum of Ba3Si6O12N2:Eu(2+) by Mg(2+) Doping.

Luminescence properties of Eu<sup>2+</sup> doped BaAl<sub>2</sub>Si<sub>2</sub>O<sub>8</sub> phosphor for white LEDs

Preparation and Luminescent Properties of SrMgAl10O17∶Eu2+ Blue Phosphor for PDP

Emission of BaMgAl_(10)O_(17):Eu~(2+) with High Concentration of Activator

High Dispersibility and Enhanced Luminescence Properties of BaMgAl10O17:Eu2+ Phosphors Derived from Molten Salt Synthesis

BaMgAl10O17:Eu blue phosphors with MgO coating and microwave irradiation