Abstract:Reversible solid oxide cells (RSOCs) are an all-solid-state electrochemical device, which can convert H2 into electricity in the fuel cell (SOFC) mode and electrolyze H2O into fuel gas in the electrolytic cell (SOEC) mode, exhibiting good application prospect in the development of carbon neutrality. However, the degradation of the air electrode caused by Cr-containing steel interconnects is a major obstacle that limits the broader application of RSOCs. Herein, the Cr poisoning effect on La0.6Sr0.4Co0.2Fe0.8O3-σ (LSCF)-based oxygen electrodes under the electrolysis mode was systematically investigated. The phase transition of the sediment during the chromium poisoning process was captured and monitored. When tested under the presence of Fe-Cr interconnects at 800 °C for 40 h, SrCrO4 on the surface of LSCF was clearly identified through XRD and Raman analysis as the main deposition, and with the prolonged operating time, LaCrO3 slowly emerged. Due to the much higher electrical conductivity of LaCrO3 compared to SrCrO4, the negative effect induced by Cr poisoning was offset along with test progressing due to the deposition transition phenomenon. Inspired by the interesting discoveries, transition from SrCrO4 to LaCrO3 can be artificially facilitated by switching the operating mode to the SOEC mode, which can partially recover the dramatic degradation caused by the Cr poisoning effect under the SOFC mode. The feasibility of the in situ electrochemical recovery method was also verified by the experimental results. The peak power density of the cells decreased from 0.829 to 0.505 W/cm2 when operating under the SOFC mode with an Fe-Cr metal connector, and after in situ electrochemical recovery in the SOEC mode, the peak power density recovered to 0.630 W/cm2. This study provides a new strategy for achieving high performance and stability of RSOCs.

Anomalous oxide scale formation under exposure of sodium containing gases for solid oxide fuel cell alloy interconnects

Iron oxide fluxing and precipitation in sulphate deposits during heat-resistant alloy corrosion in simulated combustion gas

An investigation of Cr vaporization from SUS430 metallic interconnect and deposition on (La,Sr)MnO 3 cathode of intermediate temperature solid oxide fuel cells

Cr-Based Alloy Used as Interconnect in Solid Oxide Fuel Cells

Effects of Mn concentration on durability of Fe-Cr ferritic steels dispersed with La 2 O 3 for solid oxide fuel cell interconnects

Properties of Fe–Cr Based Alloys As Interconnects in a Solid Oxide Fuel Cell

Metallic interconnects for solid oxide fuel cell: Performance of reactive element oxide coating during long time exposure

Characterization of La0.8Sr0.2Co0.5Mn0.5O3-δ Coating on Alloy Interconnect in SOFC

Corrosion behavior of Fe based container alloys in molten Na2CO3-K2CO3 as thermal energy storage medium for reversible solid oxide cells

Effect of Nb Addition on Oxidation Mechanisms of High Cr Ferritic Steel in Ar–H2–H2O

Evaluation of Protective La0.67Sr0.33MnO3–δ Coatings on Various Stainless Steels Used for Solid Oxide Fuel Cell Interconnects

Mechanical characterization of oxide coating–interconnect interfaces for solid oxide fuel cells

High-Temperature Oxidation Properties and Microstructural Evolution of Nanostructure Fe-Cr-Al ODS Alloys

Initial stage oxidation corrosion of commercial ferritic stainless steels with different Cr contents at 650 °C for solid oxide fuel cells

The Detection of Monoclinic Zirconia and Non-Uniform 3D Crystallographic Strain in a Re-Oxidized Ni-YSZ Solid Oxide Fuel Cell Anode

Metallic Interconnects for Solid Oxide Fuel Cell: Performance of Reactive Element Oxide Coating During 10, 20 and 30 Months Exposure

Discussion on some problems about the study of metallic interconnect for SOFC

In Situ Electrochemical Recovery: Sediment Transformation under Chromium Poisoning in Reversible Solid Oxide Cells with La0.6Sr0.4Co0.2Fe0.8O3-σ-Based Oxygen Electrodes

Protective coatings for Cr2O3-forming interconnects of solid oxide fuel cells

High-entropy FeCoNiMnCu alloy coating on ferritic stainless steel for solid oxide fuel cell interconnects

Effect of Rare Earth Y and Metal X (Co, Mn, Ni, Cu) Elements on Cr Diffusion Behavior of SOFC Metallic Interconnect