Abstract:A series of Ti–Cu–Ni alloys with Ti content as high as 50–70 at. % expected to possess potential high glass-forming ability (GFA) was designed according to the e criterion (Xia, M. X., Zhang, S. G., Ma, C. L., and Li, J. G., “Evaluation of Glass-Forming Ability for Metallic Glasses Based on Order-Disorder Competition,” Appl. Phys. Lett. Vol. 89, 2006, pp. 091917-1–091917-3) and were prepared by melt spinning and suck casting methods. The samples were examined by X-ray diffractometry, differential scanning calorimetry, optical microscopy, scanning electronic microscopy, and quasistatic compression test. The GFA of the melt-spun ribbons is enhanced with increasing e. Ti58Cu32Ni10 alloy with the maximum designed e value of 0.542 exhibits best GFA with a glass transition temperature of 627 K and a wide supercooled liquid region of 45 K. However, this alloy failed to form a fully glassy rod of 1 mm in diameter. Room temperature compression tests reveal that the 1 mm diameter Ti58Cu32Ni10 glass composite exhibits work-hardening characteristic, with ultimate compressive stress of 2418 MPa, yielding stress σ0.2 of 1448 MPa and about 7.8 % plastic strain. The combination of high strength and ductility was attributed to a dendritic TiCu(Ni) network embedded in the hard glass matrix.

Formation of New Ti-based Metallic Glassy Alloys

Cu-based bulk glassy alloys with high tensile strength of over 2000 MPa

A Ti-based bulk glassy alloy with high strength and good glass forming ability

PREPARATION AND PROPERTIES OF HIGH STRENGTH BULK METALLIC GLASS Ti_(53)Cu_(15)Ni_(18.5)Al_7M_3Si_3B_(0.5) (m=zr, Hf, Sc)

Cu-Based Bulk Glassy Alloys with Good Mechanical Properties in Cu-Zr-Hf-Ti System

Formation and mechanical properties of bulk Cu-Ti-Zr-Ni metallic glasses with high glass forming ability

High-strength Cu-based bulk glassy alloys in Cu–Zr–Ti and Cu–Hf–Ti ternary systems

Formation and Thermal Properties of Ti-Based Bulk Amorphous Alloy

Bulk metallic glass formation in the (Ti,Zr)-(Ni,Cu)-S system

Centimeter-sized Ti-based Bulk Metallic Glass with High Specific Strength

Formation, Thermal Stability and Mechanical Properties of Ti42.5Zr7.5Cu40Ni5Sn5 Bulk Metallic Glass

Formation and Compressive Properties of A Ni-Ti-Zr-Al-Cu-Si Amorphous Alloy

Structure and properties of Zr–Ta–Cu–Ni–Al bulk metallic glasses and metallic glass matrix composites

A New Centimeter‐Sized Ti‐Based Quaternary Bulk Metallic Glass with Good Mechanical Properties

Glass Formation and Mechanical Properties of Ti–Cu–Ni Alloys with High Ti Content

Formation and mechanical properties of Cu_(58)Zr_(20)Ti_(20)Mo_2 bulk metallic glass

Synthesis,structure and Mechanical Properties of Zr-Cu-based Bulk Metallic Glass Composites

Formation, Thermal Stability and Mechanical Properties of Zr-Nb-Cu-Ni-Al Bulk Metallic Glasses

Glass Forming Ability and Mechanical Properties of New Ni-Based Bulk Metallic Glasses

Preparation, Characterization, and Properties of Novel Ti-Zr-Be-Co Bulk Metallic Glasses.

Crystallization and mechanical behavior of (Hf, Zr)–Ti–Cu–Ni–Al metallic glasses