Abstract:Monocrystalline silicon wafer is the most important raw material in chip manufacturing; wire sawing is the most common processing method of monocrystalline silicon wafer. The residual stress generated by cutting affects the subsequent polishing costs directly, as well as the fracture strength and mechanical integrity of the monocrystalline silicon wafer, thus affecting the service performance. In this paper, the generation mechanism of residual stress was analyzed based on diamond wire sawing technology. Then, based on Drucker-Prager (D-P) plastic constitutive model, the magnitude and distribution of residual stress of monocrystalline silicon chip under different process parameters were simulated by ABAQUS simulation software. Finally, the experiment of ultrasonic vibration–assisted diamond wire saw cutting monocrystalline silicon was conducted, and the residual stress of monocrystalline silicon chips were detected by blind hole method. During the detection, the strain values before and after drilling in three directions of monocrystalline silicon chips were measured by strain gauge rosette, and then the residual stress values were determined according to the strain values and the residual stress calculation theory. The experimental results showed that residual compressive stress remains on the surface of silicon wafer in both conventional wire sawing and ultrasonic vibration–assisted wire sawing. The residual compressive stress increases with the increase of the axial speed of wire saw, decreases with the increase of the wire saw feed speed, and fluctuates with the increase of the workpiece rotation speed. The residual compressive stress on the surface of the silicon wafer by ultrasonic vibration–assisted wire sawing is larger than that by conventional wire sawing. The simulation and experimental results have the same trend, which verifies the validity of the finite element model in this paper and provides theoretical support for the subsequent processing of single crystal silicon.

Raman Online Measurement of Stress Resulting from Micromachining

Study of Local Stress Using Stress-Absorbing Si Diaphragm

Micro-Raman spectroscopy measurement of stress in silicon

Study of techniques for measuring residual stress in micromachined films

A Nondestructive Raman Spectra Stress 2D Analysis for the Pressure Sensor Sensitive Silicon Membrane

Residual Stress Characterization in Microelectronic Manufacturing: an Analysis Based on Raman Spectroscopy

Generation and distribution of residual stress during nano-grinding of monocrystalline silicon

The surface residual stress of monocrystalline silicon in ultrasonic vibration–assisted diamond wire sawing

EXPERIMENTAL MICRO-RAMAN ANALYSIS OF RESIDUAL STRESS IN POLYSILICON FILMS

Characterization of Residual Stress in SOI Wafers by Using MEMS Cantilever Beams

Micro-Raman Spectroscopy Analysis of Residual Stress in Polysilicon MEMS Resonators

Measurement of Residual Stress in a Multi-Layer Semiconductor Heterostructure by Micro-Raman Spectroscopy

Two-dimensional stress measurement of a micromachined piezoresistive structure with micro-Raman spectroscopy

Decoupling analysis of stress components on monocrystalline silicon using angle-resolved oblique backscattering Raman spectroscopy

The resolution and repeatability of stress measurement by Raman and EBSD in silicon

A Novel Approach to Study Patterned Thin Film Local Stress for Microelectronics Application

Residual Stress Measurement and Analysis in Multilayer Film Si- Substrate Structure by Micro-Raman Spectroscopy Technique

Ultra-sensitive, Highly Reproducible Film Stress Characterization Using Flexible Suspended Thin Silicon Plates and Local Curvature Measurements

Size Effect on Raman Measured Stress and Strain Induced Phonon Shifts in Ultra-Thin Film Silicon

Measurement of Young's modulus and residual stress of silicon microstructures

Residual Stress Measurement on a MEMS Structure With High-Spatial Resolution