Abstract:The angle of repose and characteristics of the base stress distribution underneath granular piles serve as essential indicators in understanding the mechanical and packing properties of particle system. One counterintuitive phenomenon is that there is an evident dip of the base stress beneath the pile apex that might have implications in the design of granular pile facilities. The repose angle and stress dip are influenced by many categories of factors and exhibit different variations. Based on the localized source method, particle packing experiments were conducted to investigate the effects of funnel height, particle size, particle shape, and packing method on the repose angle and the vertical stress distribution of granular piles. The experimental results show that the repose angle of piles of irregular particle shape and higher funnel height is much larger, but there is a decreasing trend of repose angle with increasing particle sizes. The natural packing angles before and after the critical collapse of granular pile exhibits periodic variation. On the other hand, the stress dip phenomenon occurred in all granular piles constructed by localized procedure. An increase in funnel height and a middle particle size mitigate the stress dip to some extent, whereas irregular particle shape exacerbates it. Comparison of the results from different packing methods reveals that larger repose angle and more pronounced stress dip are observed in confined packing piles compared to that in free packing piles. Considering a growth rate of less than 5 %, the average vertical stress under the sand silo reaches saturation state. Moreover, the pressure on the silo wall increases with the height of silo pile but remains somewhat lower than predicted by the Ketchum equation and current design values.

A New Experiential Measurement for the Angle of Repose of Desert Sand

Discrete Element Modeling of Sand Behavior in a Biaxial Shear Test

Influencing Factors of Repose Angle of Sand Dunes: an Experiment

Influential Factors on the Repose Angle of Desert Sands

Experiment of initial relative density effects on sand strength

Error impact analysis and experimental research for absolute testing of spherical surfaces

The Angle of Repose and Base Stress Distribution of Granular Piles: an Experimental Investigation

Measurement of Small Strain Shear Modulus of Clean and Natural Sands in Saturated Condition Using Bender Element Test

Formula for inclination angle of shear band based on soil state and microscopic characteristics in sands

Experiment on Angle of Repose and Angle of Surface Friction of Cohesionless Sediment

A P-Y Curve Method for Horizontal Bearing Characteristics of Single Batter Pile in Sands

On unified characterization of wave velocity of sand: A focus on effect of particle shape

The shape of sand particles: Assessments of three-dimensional form and angularity

Experimental Research On Behaviors Of Saturated Loose Sand Subjected To Oblique Ellipse Stress Path

Research on representation of particle size distribution for standard sands

A New Instrument for Testing Wind Erosion by Soil Surface Shape Change

Investigation techniques and physical aspects of the angle of repose of granular matter

Experimental study on anisotropic unloading mechanical behavior of bedded sandstone

Study on the Mechanical Behavior of Sands Using 3D Discrete Element Method with Realistic Particle Models

Experimental Measurement Of Wind-Sand Flux And Sand Transport For Naturally Mixed Sands

Difference Between Static and Dynamic Angle of Repose of Uniform Sediment Grains