Abstract:The lateral bearing performance of a defective pile-supported wharf located on a slope was investigated through centrifuge modeling, and a numerical model was employed to back-analyze the centrifuge test data. The pile foundation system was composed of double-plumb, single-plumb, and batter piles, and the defects were located at the front row of the double-plumb piles. The failure mode, bearing lateral load, bent displacement, and pile bending moments were examined. The results show that overturning with slight torsion occurred in the bent under the lateral load. The piles clearly deformed around defects and were separated from the soil on the landside. The lateral bent displacement increased rapidly after a threshold lateral load value was reached. The bending moments were generally positive (i.e., the side facing the water was in tension) in the upper parts and negative in the lower parts of the double-plumb piles. The bending moments of the double-plumb pile heads increased with the lateral load, whereas the bending moments directly underneath the slope surface exhibited decreasing-constant tendencies with increasing lateral load. The bending moment of the single-plumb pile was generally positive above the slope surface and in compression below the slope surface, and decreasing-constant tendencies were observed with increasing lateral load just below the slope surface. The bending moment of the forward batter pile was negative and decreased with the lateral load around the slope surface and in the middle of the soil. The bending moment of the backward batter pile was generally positive above the slope surface, negative below the slope surface, and remained almost constant around the soil.

A P-Y Curve Method for Horizontal Bearing Characteristics of Single Batter Pile in Sands

MPM Modeling of Pile Installation in Sand: Contact Improvement and Quantitative Analysis

Lateral Bearing Performance of a Defective Pile-Supported Wharf with Batter Piles

Large Deformation Analysis of Intermittent Pile Penetration into Dense Sand Incorporating a State Dependent Mohr–Coulomb Model

Centrifuge Model Tests on Laterally Loaded Piles in Sand

Effect of Loading Rate on Lateral Pile-Soil Interaction in Sand Considering Partially Drained Condition

Performance of laterally loaded H-piles in sand

Model tests on characteristics of ocean and offshore elevated piles with large lateral deflection

Model Test Study of Bearing Behavior of Small Prefabricated Piles in Soft Soil Area

Centrifuge Modelling of Lateral Loading Behaviour of a “Semi-Rigid” Mono-pile in Soft Clay

Quantifying the Influence of Pile Diameter on the Load Transfer Curves of Laterally Loaded Monopile in Sand

Numerical analysis of bearing behaviors of single batter piles under horizontal loads in various directions

A Simplified Analytical Method of Lateral Bearing Capacity of Rigid Single Pile Considering All Soil Reactions in Sand

FEM Analysis and Simplified Approach for a Single Energy Pile Subjected to Thermomechanical Loads

Field and Numerical Study of the Lateral Response of Rigid Piles in Sand

New P-Y Curve Model Considering Vertical Loading for Piles of Offshore Wind Turbine in Sand

Influence of Pile Diameter and Aspect Ratio on the Lateral Response of Monopiles in Sand with Different Relative Densities

A Multi-Axial Bounding Surface P-Y Model with Application in Analyzing Pile Responses under Multi-Directional Lateral Cycling

Accumulated response of single batter pile under lateral cyclic loading in sand

Bearing capacity and deflection behaviors of large diameter monopile foundations in sand seabed

Investigation of the Vertical Responses of 2 × 2 Square Flexible Batter Pile Groups in Sand