Abstract:At the University of Pisa, an experimental campaign was performed with the purpose of qualifying the ITER Vacuum Vessel Pressure Suppression System (VVPSS) and studying the Direct Contact Condensation at sub-atmospheric conditions. With financial support from ITER Organization, a Large-Scale Experimental Facility was designed and built to investigate the steam condensation in the operation conditions of the ITER VVPSS. The experimental tests were performed by injecting steam, produced by an electric steam generator (1.7 MW of power), through a multi-hole sparger into a condensation tank called Experimental Test Tank (ETT). On the sparger support, strain gauges and an accelerometer were installed to analyse the structural behaviour during the experimental tests. Under certain thermal hydraulic conditions (low subcooling and low steam mass flow rate) a large steam pocket can form and collapse causing high loads on the sparger structure. The aim of this study was comparing numerical fluid dynamics and structural analyses with the experimental results in order to estimate the pressure impulse caused by bubble collapse. The bubble collapse was simulated by means of ANSYS Fluent code in order to analyse the bubble dynamics and to determine the pressure impulse. The shape, the dimension and the collapse time of steam pocket were experimentally determined by means of an image analysis of video recorded during the tests. The numerical and experimental maximum steam bubble volume at the final stage of the transient before the detachment shows a good agreement with an error of 6 %. The pressure load was estimated at 5 different points of the simulation domain; the maximum pressure impulse on the sparger is 1.15 bar and has a duration of 40 ms. A dynamic structural FEM analysis was performed applying the pressure impulses on the sparger in order to evaluate the accelerations. The average value of RMS, maximum, minimum and duration of the experimental acceleration signals was obtained and compared to the numerical one. The errors of the RMS, the maximum and the minimum acceleration of the sparger are 16 %, 35 % and 51 %, respectively. The time duration of the oscillations is in good agreement (the error is only 2.54 %).

Structural Analysis of the ITER VV Lower Port Region

Structural Analysis of ITER Lower In-Vessel-Viewing Port

Structural Integrity Analysis for Final Design of ITER Gas Fueling Manifold

Numerical analysis on neutron shielding structure of ITER vacuum vessel

The Effect of Hydrostatic Pressure and Seismic Load on Iter Lower Cryopump Ports

The Structure Analysis of ITER Cryostat Based on the Finite Element Method

Modal and Structural Analysis on a Main Feed Water Regulating Valve under Different Loading Conditions

Preliminary Analysis of In-Vessel First Wall Cooling Pipe Ruptures for ITER

Thermal Hydraulic Characteristics During Ingress of Coolant and Loss of Vacuum Events in Fusion Reactors

Safety Analysis of Metallic Tokamak-I Against Electromagnetic and Structural Loads

Structural and thermal fluid dynamics analyses of the ITER Pressure Suppression System considering no stable steam condensation regimes

Experimental and Numerical Studies on Heat Transfer and Fluid Flow Characteristics in A Vacuum Vessel of Fusion Reactor after the Loss-Of-Vacuum-Events Occurred

Preliminary Analysis of the Thermal-Hydraulic Behavior Induced by First Wall Coolant Pipe Leakage Accidents for ITER

Finite Element Analysis of Tangential Rectangle Joint Pipe on the Shell of an Cyclone

Parametric Analysis of Influence Factors to the In-Vacuum Vessel Loca for Cfetr Based on Relap5

A Theoretical Model for the Circumferential Strain of Immersed Tunnel Elements under Tidal Load

THE LOAD ANALYSIS OF PREFABRICATED CONTAINER BASED ON THE ITER PPEN SUBSTATION

The diagnostic rack design and the functional demonstration of the locking mechanism for ITER diagnostic lower port integrations

Updated Thermal-Mechanical Analysis of DFLL-TBM for ITER

Numerical Analysis of Stress and Design of Structure Based on Vacuum Cold-Box of Cold Neutron Source

Seismic Analysis under SL-1 of New Structure Support Frame for ITER PF Converter System