Abstract:At the University of Pisa, an experimental campaign was performed with the purpose of qualifying the ITER Vacuum Vessel Pressure Suppression System (VVPSS) and studying the Direct Contact Condensation at sub-atmospheric conditions. With financial support from ITER Organization, a Large-Scale Experimental Facility was designed and built to investigate the steam condensation in the operation conditions of the ITER VVPSS. The experimental tests were performed by injecting steam, produced by an electric steam generator (1.7 MW of power), through a multi-hole sparger into a condensation tank called Experimental Test Tank (ETT). On the sparger support, strain gauges and an accelerometer were installed to analyse the structural behaviour during the experimental tests. Under certain thermal hydraulic conditions (low subcooling and low steam mass flow rate) a large steam pocket can form and collapse causing high loads on the sparger structure. The aim of this study was comparing numerical fluid dynamics and structural analyses with the experimental results in order to estimate the pressure impulse caused by bubble collapse. The bubble collapse was simulated by means of ANSYS Fluent code in order to analyse the bubble dynamics and to determine the pressure impulse. The shape, the dimension and the collapse time of steam pocket were experimentally determined by means of an image analysis of video recorded during the tests. The numerical and experimental maximum steam bubble volume at the final stage of the transient before the detachment shows a good agreement with an error of 6 %. The pressure load was estimated at 5 different points of the simulation domain; the maximum pressure impulse on the sparger is 1.15 bar and has a duration of 40 ms. A dynamic structural FEM analysis was performed applying the pressure impulses on the sparger in order to evaluate the accelerations. The average value of RMS, maximum, minimum and duration of the experimental acceleration signals was obtained and compared to the numerical one. The errors of the RMS, the maximum and the minimum acceleration of the sparger are 16 %, 35 % and 51 %, respectively. The time duration of the oscillations is in good agreement (the error is only 2.54 %).

The Effect of Hydrostatic Pressure and Seismic Load on Iter Lower Cryopump Ports

Structural Analysis of the ITER VV Lower Port Region

Structural Analysis of ITER Lower In-Vessel-Viewing Port

Numerical analysis on neutron shielding structure of ITER vacuum vessel

Modal and Structural Analysis on a Main Feed Water Regulating Valve under Different Loading Conditions

The Structure Analysis of ITER Cryostat Based on the Finite Element Method

Instability Analysis and Development of High Pressure Hydrogen Storage Vessels

Structural and thermal fluid dynamics analyses of the ITER Pressure Suppression System considering no stable steam condensation regimes

Thermal Hydraulic Characteristics During Ingress of Coolant and Loss of Vacuum Events in Fusion Reactors

Fluid–Structure Coupling Analysis of the Stationary Structures of a Prototype Pump Turbine during Load Rejection

Multi-Scale Failure Analysis Model for Cryogenic Pressure Vessel Under Combined Thermal Stress and Mechanical Stress

Numerical Study on the Flow and Heat Transfer Characteristics in CFETR Cryostat During a Loss of Vacuum

Mechanical property and sealing performance analysis of the diaphragm compressor cylinder head for the hydrogen refueling station under the mutation impact load

Research and Analysis on Tensile and Compressive Fatigue Performance of Cryogenic Axial Insulation Breaks

The Thermal-Fluid-solid Coupling Effect in Nuclear Reactor Vessel with Direct Vessel Injection

Neutronics Analysis of the Upper Port for ITER

Numerical Study on the Flow and Structural Characteristics of a Large High Head Prototype Pump-Turbine under Different Operating Conditions

Study on the liquid level characteristics and reconstruction strategy of the in-vessel pressurizer under ocean conditions

Structural characteristics analysis of extra–high–head pump–turbine-unit under extreme-pressure working-conditions

The Influence of Hydraulic Characteristics on Structural Performance in a Pump-Turbine under No-Load Conditions

EFFECTS OF HEAVING CONDITION ON CHARACTERISTICS OF SYSTEM UNDER FORCED CIRCULATION AND NATURAL CIRCULATION