Abstract:AlN skeleton structure-reinforced highly oriented graphite flake (AlN/GF) composites have become a promising candidate for thermal management materials owing to their high thermal conductivity and low thermal expansion. However, the applications of AlN/GF composites are still limited by their poor mechanical properties. Herein, a carbon nanotube-coated alumina (Al2O3@CNT) hybrid was used as a reinforcement to improve the mechanical performance of AlN/GF composites prepared via vacuum infiltration followed by spark plasma sintering. It was found that the relative density and orientation degree of the composites decreased slightly with an increase in the Al2O3@CNT content from 0 to 2 wt%. However, the fracture toughness and bending strength of the composites improved significantly after the introduction of the Al2O3@CNT hybrid reaching up to 1.66 MPa∙m1/2 and 95 MPa, respectively, which correspond to an improvement of approximately 50% and 20% over those of the AlN/GF composite. With the addition of the Al2O3@CNTs, the thermal expansion of the composites increased from 7.3 × 10-6/K to ∼15.5 × 10-6/K, while the thermal conductivity decreased from 442 to ∼253 W/m/K. The toughening and strengthening mechanisms as well as the thermal impact mechanism of the composites were also investigated.

Carbon nanotube toughened aluminium oxide nanocomposite

Mechanical properties of Al matrix composites reinforced with carbon nanotubes prepared by powder metallurgy

Toughening And Reinforcing Alumina Matrix Composite With Single-Wall Carbon Nanotubes

Mechanical Properties and Fracture Characterization of 2024al Composite Reinforced with Carbon Nanotube

A New Structure for Multi-Walled Carbon Nanotubes Reinforced Alumina Nanocomposite with High Strength and Toughness

Well-Dispersed Carbon Nanotubes for Greatly Enhanced Mechanical Properties of Alumina-Based Composites

Preparation and Mechanical Properties of Carbon Nanotubes Reinforced Alumina Ceramic Composite

Colloidal Processing of Carbon Nanotube/Alumina Composites

Processing and Properties of Carbon Nanotubes Reinforced Aluminum Composites

The effect of carbon nanotubes microstructures on reinforcing properties of SWNTs/alumina composite

Electrical, Mechanical, and Thermal Properties of Multiwalled Carbon Nanotube Reinforced Alumina Composites

Fabrication and Tribological Properties of Carbon Nanotubes-Aluminum Composites

Preparation and Microstructure of Multi-Wall Carbon Nanotubes-Toughened Al2O3 Composite

Microstructure-toughening Relation in Alumina Based Multiwall Carbon Nanotube Ceramic Composites

Effect of Carbon Nanotube (CNT) Content on the Properties of In-Situ Synthesis CNT Reinforced Al Composites

Fabrication of Carbon Nanotube Reinforced Al Composites with Well-Balanced Strength and Ductility

Preparation of MWNTs/Al2O3 Composites and Their Mechanical and Electrical Properties

Microstructure evolution and mechanical properties of carbon nanotubes reinforced Al matrix composites

Fabrication of Aluminum Matrix Composite Reinforced with Carbon Nanotubes

Carbon Nanotube-Reinforced Aluminum Matrix Composites Enhanced by Grain Refinement and in Situ Precipitation

Effect of carbon nanotube hybrid on the microstructure and properties of AlN skeleton-reinforced highly oriented graphite flake composites