Abstract:A new study of the preparation of nanocrystalline titanium dioxide (TiO2) fibers is reported in the paper, which were prepared by sol–gel process with titanium acetate [Ti(CH3COO)4] as precursor. After that, centrifugal spinning and steam atmosphere heat-treatment were used to obtain final fibers. Here, the molecule structure of precursor was analyzed and the TiO2 fibers obtained were characterized. Additionally, the effects of the silica (SiO2) doping were discussed in this paper. By the Fourier transformation infrared spectrum analysis, the chain structure of –O–Ti–O–Ti–O– was confirmed in the Ti(CH3COO)4 precursor, as a result the precursor spinning solution showed a good spinning performance. And the pyrolysis process of precursor fibers was analyzed with the help of DSC–TG method. The phase of TiO2 fibers obtained after heat-treatment with steam atmosphere was characterized mainly by the X-ray diffractometer (XRD), from the XRD curves, the result that the SiO2 doping can efficiently inhibit the grain growth of TiO2 fibers could also be verified. The microstructure of the TiO2 fibers was observed by scanning electron microscope, which showed that diameter of TiO2 fibers obtained with excellent continuity are from 5 to 10 μm. At last, the photocatalytic property of TiO2 fibers was also tested.

Preparation of Zirconia Fibers via a Simple Aqueous Sol-Gel Method

Preparation and Application of Spinnable Zirconium Sol I.Preparation of Continuous Zirconia Fiber

Preparation and Characterization of 8mol％ Yttria-stabilized ZrO2 (8YSZ) Fibers Prepared by Sol-Gel Method

Preparation and Thermal Stability of Zirconia-Doped Mullite Fibers Via Sol-Gel Method

A General Propylene Epoxide-assisted Sol-Gel Route for the Synthesis of ZrO2-SnO2 Composite Sols

Electrospun zirconia nanofibers and corresponding formation mechanism study

Preparation of Zirconia Powders by Sol-gel Process

Oxidation Protection of Carbon Fiber by Sol-Gel Derived Boron Doped Yttria Stabilized Zirconia Coatings

Fabrication of High‐Strength Continuous Zirconia Fibers and Their Formation Mechanism Study

Preparation of YIG Single Crystal Nanofibers Via an Electrospinning Technique

Preparation of high-strength alumina-zirconia fibers by the sol-gel method combined with two-step sintering processes

Synthesis of Monolithic Zirconia with Macroporous Bicontinuous Structure Via Epoxide-Driven Sol–gel Process Accompanied by Phase Separation

Mullite Fiber Prepared by Sol-Gel Method Using Low-Molecular-Weight Acids as Modifying Agents

Sol–gel Preparation of ZrC–ZrO2 Composite Microspheres Using Fructose As a Carbon Source

Titanium Dioxide Fibers Prepared by Sol–gel Process and Centrifugal Spinning

A Novel Preparation Process for Thermally Stable Ultrafine Tetragonal Zirconia Aerogel

Fabrication and Characterization of Size-Controlled Single-Crystal-like PZT Nanofibers by Sol–gel Based Electrospinning

Zirconia-alumina multiphase ceramic fibers with exceptional thermal stability by melt-spinning from solid ceramic precursor

Effect of Heat-treatment Atmosphere on Preparation of Continuous Zirconia Fibers

Modification of Zirconia Fiber to reinforce ZrO2 Aerogels

Preparation of ZTA composite ceramics derived from sol–gel method by DIW printing