Abstract:Surface modification of carbon fiber with 1,1-dihydroperoxycyclohexane (DHPC) before application of SiO 2 barrier coating was studied. IR spectroscopy showed presence of the COOH carboxyl groups on the surface of modified carbon fibers. The modified surface has less hydrophobicity due to the presence of polar groups, which contribute to a change in the wettability of the fiber by the sol–gel solution and the adhesion of the oxide coating to the fiber surface. The quality and thickness of the oxide coatings were assessed by scanning electron microscopy. The use of DHPC leads to oxidation of the carbon fiber, making surface longitudinal stripes deeper. To determine the effect of DHPC modification on the properties of the fiber surface, a SiO 2 coating was applied by immersion in a tetraethoxysilane sol. DHPC modification leads to the formation of a uniform SiO 2 coating on the fiber surface. After the heat treatment, the coating thickness on the DHPC–modified fibers is 130 ± 30 nm. Analysis of the IR spectra showed that the addition of DHPC to the sol leads to an increase in the intensity of the Si–O–Si, Si–OH, and OH absorption bands, which are characteristic of the hydrolysis and polycondensation products of tetraethoxysilane. In the wavenumber range of 400–1200 cm –1 , the Si–O–Si fragments form, which is confirmed by the presence of bands of Si–O– deformation bond at ν = 881 and 442 cm –1 . The introduction of DHPC into the sol promotes the formation of a uniform coating on the carbon fibers. The coating thickness on the initial fibers reaches 410±100 nm at room temperature, decreasing to 190±60 nm after heating. The fiber and sol modification contribute to formation of a uniform coating with a thickness of 200 ± 70 nm and 130 ± 30 nm before and after the heating, respectively. DHPC modification of the fiber surface and tetraethoxysilane sol promotes the formation of continuous, uniform, and quality SiO 2 coatings on the surface of carbon fibers.

Oxidation Protection of Carbon Fiber by Sol-Gel Derived Boron Doped Yttria Stabilized Zirconia Coatings

Combined Zr and Y Phosphate Coatings Reinforced with Chemically Anchored B2O3 for the Oxidation Inhibition of Carbon Fiber

Preparation and ablation resistance of carbon fiber with yttrium silicate coating

Effect of the Y2O3 amount on the oxidation behavior of ZrB2-SiC-based coatings for carbon/carbon composites

High temperature oxidation resistance of Y2O3 modified ZrB2-SiC coating for carbon/carbon composites

ZrB2 particles reinforced glass coating for oxidation protection of carbon/carbon composites

Oxidation resistance improvement of carbon fiber nonwoven fabrics through SiC coating technology

Synthesis and characterization of high-temperature resistant yttrium-doped lanthanum monazite coatings on SiC fibers

Industrial and environmental significance of photonic zirconia nanoflakes: Influence of boron doping on structure and band states

Thermal and oxidation protection of carbon fiber by continuous liquid phase pre-ceramic coatings for high temperature application

Synthesis and Characterization of Doped Nano-Sized Ceria–zirconia Solid Solutions

Fabrication and oxidation resistance of mullite/yttrium silicate multilayer coatings on C/SiC composites

Effect of boronizing treatment on the oxidation resistance of Zr2(AlSi)4C5/SiC composite

Oxidation Behavior of Carbon Fibers in Ceramizable Phenolic Resin Matrix Composites at Elevated Temperatures

Effect of Yttrium on the Properties of Carbon Fiber-Reinforced ZrB2–SiC Composites

Multi-composition Coating for Oxidation Protection of Modified Carbon-Bonded Carbon Fiber Composites

Preparation and Thermal Stability of Zirconia-Doped Mullite Fibers Via Sol-Gel Method

A dense ZrB2-SiC-Si/SiC-Si coating to protect carbon/carbon composites against oxidation at 1773 K and 1973 K

Oxidation of Short Carbon Fiber Reinforced Zrb2-Sic Ceramics under Atmospheric and Oxyacetylene Torch Conditions

Preparation of Al 2 O 3 –zro 2 –Y 2 O 3 Composite Coatings by a Modified Sol–Gel Technique for Thermal Barrier Application

Effect of Surface Modification of Carbon Fibers on the Formation of SiO2 Coatings