Abstract:(100) Oriented Pb x Sr1−x TiO3 (PSTO) thin films are prepared on indium tin oxide (ITO)/glass substrates by sol–gel technique while inserting doped PbTiO3 (PTO)-inducing layer in between. The effect of tensile stress in PSTO on tunability and (100) orientation of the thin films was investigated using X-ray diffraction, scanning electron microscopy, transmission electron microscope, and atomic force microscope, respectively. Results show that PSTO thin film deposited on doped PTO has (100) oriented structure while it is randomly oriented when deposited directly on the ITO/glass substrate. Lattice mismatch between PSTO and PTO appears, in which the in-plane lattice constant c is 0.3922–0.3924 nm in the former and 4.02–4.07 nm in the latter, respectively, contributing tensile stress in the PSTO due to different lattice constants between them. The stress in the PSTO thin film is 3.04, 3.15, 3.59 and 4.47 GPa when the doped PTOs are Fe–PTO, Tb–PTO, Co–PTO and Zn–PTO, respectively. The orientation degrees of PSTO thin films are from 89.63, 90.31, 91.92 to 93.29 % with increasing stress of PSTO on Fe–PTO, Tb–PTO, Co–PTO and Zn–PTO, respectively. Tunabilities of the well-oriented PSTO thin films increase in ascending order of 63 < 65 < 69 < 73 % when induced by oriented PTO layers of Fe–PTO, Tb–PTO, Co–PTO and Zn–PTO, respectively, which is in accordance with the degree of (100) orientation appearing in the thin films. The high tunability appears in the PSTO thin film while high (100) orientation is derived from the tensile stress. It is much higher than that of randomly oriented PSTO thin film.

Growth of highly-oriented CaCu3Ti4O12 thin films on SrTiO3 (100) substrates by a chemical solution route

Growth of Highly-Oriented CaCu 3 Ti 4 O 12 Thin Films on SrTiO 3 (1 0 0) Substrates by a Chemical Solution Route

Control of Tensile Stress on Inducing Formation and Tunability of (100) Oriented Pb X Sr1−x TiO3 Thin Films

Nanocomposite-Like Structure in an Epitaxial Cacu3ti4o12 Film on Laalo3(001)

The structural and electrical properties of oriented SrTiO3 films prepared by metal organic deposition method

Growth of (Ba,Sr)TiO 3 Thin Films by MOCVD: Stoichiometry Effects

Epitaxial Growth of Dielectric CaCu3Ti4O12 Thin Films on (001) LaAlO3 by Pulsed Laser Deposition

Preparation and Structure of La_(0.5)Ca_(0.5)Mn_xTi_(1-x)O_3 Thin Film Deposited by Magneto Controlled Sputtering

Structure and Dielectric Properties of Highly (100)-Oriented PST Thin Films Deposited on MgO Substrates

The Microstructure and Magnetic Property of TiO2‐terminated SrTiO3 Substrate Selected Growth Cubic Phase CaRuO3 Film

(111)-Oriented Batio3 Thin Films Hydrothermally Formed On Tio2/Si Substrate

Growth of Cubic CdS Films on TiO2-terminated (100) SrTiO3 Substrate

The Growth and Phase Transitions of Epitaxial Pb(Zr0.95ti0.05)O-3 Thin Films Prepared by Sputter Deposition Combined with Post-Annealing on Srtio3(1 0 0)

Surface step terrace tuned microstructures and dielectric properties of highly epitaxial CaCu 3 Ti 4 O 12 thin films on vicinal LaAlO 3 substrates

X-Ray Analysis Of Epitaxial Pbtio3 Thin Film Grown On An (001)Srtio3 Substrate By Metal-Organic Chemical Vapour Deposition

Preparation and properties of CaCu3Ti4O12 thick film by aerosol deposition method

Formation of Atomically Smooth Surfaces on Srtio3 Substrates for Epitaxial Film Growth

Growth of SrTiO3 Thin Films on BaxSr1−xTiO3 (x=0.3, 0.5) Seed Layers on Ni (200) Substrates Using Spin Coating Technique

Epitaxial growth of ferroelectric PbTiO3 thin films by metalorganic chemical vapor deposition

Impact of Cationic Stoichiometry on Physical, Optical and Electrical Properties of SrTiO3 Thin Films Grown on (001)-Oriented Si Substrates

EPITAXIAL GROWTH OF <font>SrTiO</font><sub>3</sub> THIN FILMS BY SOL-GEL SYNTHESIS ON <font>LaAlO</font><sub>3</sub> AND <font>Ni</font> SUBSTRATES