Abstract:Inductively coupled plasma (ICP) etching of GaN with an etching depth up to 4 μm is systemically studied by varying ICP power, RF power and chamber pressure, respectively, which results in etch rates ranging from ∼370 nm/min to 900 nm/min. The surface morphology and damages of the etched surface are characterized by optical microscope, scanning electron microscope, atomic force microscopy, cathodoluminescence mapping and photoluminescence (PL) spectroscopy. Sub-micrometer-scale hexagonal pits and pillars originating from part of the structural defects within the original GaN layer are observed on the etched surface. The density of these surface features varies with etching conditions. Considerable reduction of PL band-edge emission from the etched GaN surface indicates that high-density non-radiative recombination centers are created by ICP etching. The density of these non-radiative recombination centers is found largely dependent on the degree of physical bombardments, which is a strong function of the RF power applied. Finally, a low-surface-damage etch recipe with high ICP power, low RF power, high chamber pressure is suggested. © 2010 Elsevier B.V. All rights reserved.

Selective etching of GaN/ AlGaN by Inductively coupled plasma

Highly Selective Dry Etching of GaN over AlGaN Using Inductively Coupled Cl2/N2/O2 Plasmas

Highly Selective Dry Etching of Gan over Algan Using Inductively Coupled Cl-2/N-2/O-2 Plasmas

Nonselective and smooth etching of GaN/AlGaN heterostructures by inductively coupled plasmas

Nonselective Etching of GaN/AlGaN Heterostructures by Cl2/Ar/BCl3 Inductively Coupled Plasmas

High Selectivity, Low Damage ICP Etching of p-GaN over AlGaN for Normally-off p-GaN HEMTs Application

Characteristics of N-Gan after Cl-2/Ar and Cl-2/N-2 Inductively Coupled Plasma Etching

Demonstration of HCl-Based Selective Wet Etching for N-Polar GaN with 42:1 Selectivity to Al0.24Ga0.76N

Characteristics of GaN Thin Films by Inductively Coupled Plasma Etching with Cl2/BCl3 and Cl2/Ar

Selective etching of GaAs substrate

The reactive ion etching characteristics of AlGaN/GaN SLs and etch-induced damage study of n-GaN using Cl2/SiCl4/Ar plasma

Highly selective dry etching of GaP in the presence of Al$_\textrm{x}$Ga$_{1-\textrm{x}}$P

Low bias electron cyclotron resonance plasma etching of GaN, AlN, and InN

Etching Damage Analysis and Optimization of Inductively Coupled Plasma Etching of GaN

Selective Dry Etching of GaAs/AlAs Based on SiCl4/SF6 Mixtures by ICP

Dry Etching Characteristics of Algan/Gan Heterostructures Using Inductively Coupled H-2/Cl-2, Ar/Cl-2 and Bcl3/Cl-2 Plasmas

Control of Inductively Coupled Plasma Etching GaN Sidewall Profiles and Etch Rate

The Effect of Inductively Coupled Plasma Etching on the I–V Curves of the Avalanche Photodiode with GaN/AlN Periodically Stacked Structure

Smooth Etching of Epitaxially Grown AlN Film by Cl2/BCl3/Ar-based Inductively Coupled Plasma

Optimization of inductively coupled plasma deep etching of GaN and etching damage analysis