Abstract:A wideband low-noise amplifier (LNA) featuring transformer-based wideband input matching is proposed for millimeter-wave applications. By analyzing the properties of conventional series input matching networks, which were widely employed in narrowband LNAs and shunt-series matching networks for bandwidth extension, a novel input matching network possessing the merits of both was proposed. For further bandwidth extension, another peak of input impedance at a higher frequency is introduced for the proposed input matching network. Moreover, it is proved that the proposed input matching network can suppress the gate resistor noise, resulting in significant noise figure (NF) improvement of an LNA. On the other hand, the NF is further reduced by connecting a transformer between the two amplification stages, which helps suppress the noise contribution from the second stage, leading to an LNA design with NF lower than 4.5 dB over a very wide operating bandwidth. To enhance the gain bandwidth, the peak distribution, including both shunt peaking and series peaking, is discussed. By appropriately distributing these peaks, which is also known as the pole-tuning technique, a wider gain bandwidth can be obtained. To validate the proposed techniques, an LNA with two common-source (CS) stages is designed and fabricated using a 65-nm CMOS process, and the overall chip size, including all pads, is only 0.26 mm². The two CS stages are cascoded for dc biasing to reduce the power consumption. Experimental results show that a peak gain of 13.5 dB is achieved within a -3-dB bandwidth from 19.2 to 42.6 GHz. The measured NF is 3.1-4.5 dB, and the input 1-dB gain compression point (IP1 dB) ranges from -13.54 to -9.89 dBm in the entire gain bandwidth. The input return loss S₁₁ is less than -10 dB over a frequency range of 16.8-38.9 GHz. Moreover, benefiting from the current-reuse technique, the power consumption of the LNA is only 6.36-mW.

A Wideband CMOS VGLNA Based on Single-to-differential Stage and Resistive Attenuator for TV Tuners

A Wideband CMOS Variable Gain Low Noise Amplifier Based on Single-to-differential Stage for TV Tuner Applications

A Wideband Cmos Variable-Gain Low Noise Amplifier with Novel Attenuator

A 6.5-12 GHz Balanced Variable Gain Low-Noise Amplifier with Frequency-Selective Non-Foster Gain Equalization Technique

Analysis and Design of Ultra-Wideband Low-Noise Amplifier with Input/Output Bandwidth Optimization and Single-Ended/Differential-Input Reconfigurability.

A 6.512-GHz Balanced Variable-Gain Low-Noise Amplifier With Frequency-Selective Gain Equalization Technique

Design and Optimization of a Milli-Meter Wave Amplifier Using Nano-Scale CMOS Devices

A Compact 2.1–39 GHz Self-Biased Low-Noise Amplifier in 65 Nm CMOS Technology

A 1.8-V CMOS Direct-Conversion Tuner for Mobile DTV Applications

A Wideband CMOS Inductorless Low Noise Amplifier Employing Noise Cancellation for Digital TV Tuner Applications

Design of Wideband Gain-variable LNA Based on Mobile Digital TV Applications

CMOS Wide Band Programmable Gain Low Noise Amplifier

A 0.18 Μm CMOS Inductorless Complementary-Noise-canceling-lna for TV Tuner Applications

A High Linearity Variable Gain LNA for WCDMA Receiver Front-End

A Sub-GHz Low-Power Receiver Employing Resistive-Feedback-Tuned LNA with 2.1-Db NF and 106-Db Gain Tuning Range

1.9&Amp;amp;#x223c;2.6ghz Tuning Range Variable Gain Low-Noise Amplifier with Digital Assisted Automatic Tuning Loop

A Wideband CMOS LNA Using Transformer-Based Input Matching and Pole-Tuning Technique

A 4.2 mm 72 mW Multistandard Direct-Conversion DTV Tuner in 65 nm CMOS

3-10 GHz Ultra-Wideband LNA with Continuously Variable Gain for Wireless Communication

A dual band CMOS two-stage variable gain low noise amplifier

An RF Front-End for a Fully Integrated CMOS DTV Tuner