Abstract:In this work, we employ response surface methodology and finite element simulation to optimize the preparation of carbon blocks via cold isostatic pressing. A response surface is developed to analyze two responses of the carbon block green body (apparent porosity and compressive strength) and optimize four factors of the fabrication process (binder content = 14 wt%, maximum particle size = 1 mm, Andreasen distribution modulus = 0.33, and compaction pressure = 200 MPa) to achieve an apparent porosity of 10.02% and a compressive strength of 46.26 MPa. Optimized parameters are found to improve micropore content, and SEM characterization reveals that the resulting microstructure consists of evenly distributed, closed circular pores, with a pore size distribution of 0.28–9.04 μm determined via mercury intrusion porosimetry. For the first time, a three-level structural model of the raw carbon block material as binder-coated particles with surface-adhered fine powders is established to carry out finite element simulations of the cold isostatic pressing process, with which mechanisms for the densification and microporosity of the carbon block are examined. Response-surface optimization of the cold isostatic pressing process facilitates reduction and uniform distribution of stress and strain within the particle-based composite, as well as improvements in relative density, reductions in pore size range, and increases in uniform microporosity. Particle size is identified as a key parameter influencing deformation under compaction, subsequent pore formation, and the resulting performance of carbon blocks.

Study on Preparation of Isotropic Graphite With Natural Amorphous Graphite

The relationship of structure and processing condition of isotopic graphite

Wettability of Natural Microcrystalline Graphite Filler with Pitch in Isotropic Graphite Preparation

Binding Natural Graphite with Mesophase Pitch: A Promising Route to Future Carbon Blocks

Effect of pore structure on the thermophysical and frictional properties of high-density graphite

Carbon Blocks from Natural Flake Graphite and Mesophase Pitch: Fabrication Processing, Microstructre, Mechanical Property, and Electrical Perfromance

Graphite Blocks with Preferred Orientation and High Thermal Conductivity

Gelcasting Process of Graphite

The Use of Asphalt Emulsions As a Binder for the Preparation of Polycrystalline Graphite

Response surface optimization and finite element simulation to prepare microporous carbon refractories via cold isostatic pressing

Preparing Amorphous Graphite/resin Bipolar Plate by Mould Pressing Process

Effect of kneading and carbonization temperature on the structure of the carbon block for thermally conductive bulk graphites

Homogenous and Highly Isotropic Graphite Produced from Mesocarbon Microbeads

Research on Graphite Powders Used for HTR-PM Fuel Elements

Improvement of Tensile Strength and Anti-Oxidation Property of Graphite Electrode for Electric Arc Furnace Through Heterogenization of Binder Pitch

Preparation of Siliconized Graphite by Liquid Silicon Infiltration of Porous Carbon Materials

Study on the Preparation of Flexible Graphite Composites

Simple routes from natural graphite to graphite foams: Preparation, structure and properties

Influence of fabricated process on mechanical properties of porous SiC-particle/ Si3N4 composites

Deformation behavior of graphite and its effect on microstructure and thermal properties of aluminum/graphite composites

Comparison of Ultrafine-Grain Isotropic Graphite Prepared from Microcrystalline Graphite and Pitch Coke