Abstract:The response surface method was used to successfully predict the optimal addition amounts of phenolic resin and bitumen binding system for cold isostatic pressing carbon blocks as 14wt% and 2wt%, respectively, and ultra-high performance carbon blocks with a compressive strength of 104.25MPa and pore sizes below 1 μm accounted for 90.8% were predicted and prepared. We proposed the phase change densification theory for pitch successfully explaining the secondary densification of carbon blocks by pitch powder during shaping and curing. Besides, In the carbonization stage with the carbon block firing schedule, we determined that the carbon structure of pitch after carbonization with the participation of the phenolic resin matrix and organic small molecules of phenolic resin volatilization and pyrolysis consisted of lamellar carbon with a greater number of defects, and proposed that the interface between the non-graphitizable carbon after the carbonization of the phenolic resin and graphitizable carbon after the carbonization of pitch is the carbon binding mode and mechanism of the nucleation and growth of domain structures at the defects of lamellar carbon. Therefore, We determined that the mosaic and fine mosaic binding between the high strength and high brittleness non-graphitizable carbon carbonization of phenolic resin and the low strength and high ductility graphitizable carbon carbonization of pitch as well as the aforementioned carbon binding mechanism based on domain structure also were the important reasons for the performance enhancement of pitch composite phenolic resin bonded carbon blocks.

Graphite Blocks with Preferred Orientation and High Thermal Conductivity

Binding Natural Graphite with Mesophase Pitch: A Promising Route to Future Carbon Blocks

Carbon Blocks from Natural Flake Graphite and Mesophase Pitch: Fabrication Processing, Microstructre, Mechanical Property, and Electrical Perfromance

Effects Of Heat-Treatment Temperature And Binder Content On The Microstructure And Thermal Conductivity Of Graphite Flake-Carbon Composites

Experiments and Modeling for Thermal Conductivity of Graphite Nanoplatelets/carbon Composites

Preparation of graphite flakes/Al with preferred orientation and high thermal conductivity by squeeze casting

Effect of kneading and carbonization temperature on the structure of the carbon block for thermally conductive bulk graphites

Preparation of Oriented Graphite/polymer Composite Sheets with High Thermal Conductivities by Tape Casting

Preparation and thermal conduction property of expanded graphite matrix composites

Anisotropic high thermal conductivity of flexible graphite sheets used for advanced thermal management materials

Material properties and structure of natural graphite sheet

Planar Lighting from Optimized Graphite Papers Made of Graphite Oxide

Response surface optimization of pitch phase change densification using composite phenolic resin co-carbonization to prepare high performance carbon refractories

Anisotropic Thermal Conductivity and Permeability of Compacted Expanded Natural Graphite

Wettability of Natural Microcrystalline Graphite Filler with Pitch in Isotropic Graphite Preparation

Ultrahigh Through-Plane Thermal Conductivity of Graphite by Reducing Inter-Plane Twist

Vertically Aligned and Interconnected Graphite and Graphene Oxide Networks Leading to Enhanced Thermal Conductivity of Polymer Composites

Homogenous and Highly Isotropic Graphite Produced from Mesocarbon Microbeads

Effects of Mesophase Pitch Raw Material on the Properties and Crystal Structure of Graphite Foams

Microstructure and properties of graphite nanoflakes/Cu matrix composites fabricated by pressureless sintering and subsequent thermo-mechanical treatment

Preparation and Performance of Mesophase Pitch Based Graphite Foam