Abstract:To accommodate the integration of renewable energy, coal-fired power plants must take on the task of peak regulation, making the low-load operation of boilers increasingly routine. Under low-load conditions, the phase transition point (PTP) of the working fluid fluctuates, leading to potential flow instability, which can compromise boiler safety. In this paper, a one-dimensional coupled dynamic model of the combustion and hydrodynamics of a supercritical boiler is developed on the Modelica/Dymola 2022 platform. The spatial distribution of key thermal parameters in the furnace and the PTP position in the water-cooled wall (WCW) are analyzed in a 660 MW supercritical boiler when parameters on the combustion side change under full-load and low-load conditions. The dynamic response characteristics of the temperature, mass flow rate, and the PTP position are investigated. The results show that the over-fire air (OFA) ratio significantly influences the flue gas temperature distribution. A lower OFA ratio increases the flue gas temperature in the burner zone but reduces it at the furnace exit. The lower OFA ratio leads to a higher fluid temperature and shortens the length of the evaporation section. The temperature difference in the WCW outlet fluid between the 20% and 60% OFA ratios is 11.7 °C under BMCR conditions and 7.4 °C under 50% THA conditions. Under the BMCR and 50% THA conditions, a 5% increase in the coal caloric value raises the flue gas outlet temperature by 32.7 °C and 35.4 °C and the fluid outlet temperature by 6.5 °C and 9.9 °C, respectively. An increase in the coal calorific value reduces the length of the evaporation section. The changes in the length of the evaporation section are −2.95 m, 2.95 m, −2.62 m, and 0.54 m when the coal feeding rate, feedwater flow rate, feedwater temperature, and air supply rate are increased by 5%, respectively.

Introduction to Simulation Computing Program of Startup Characteristic for 1000 MW Ultra Supercritical Boiler

Start Up Simulation Calculation of 600MW Sliding Pressure Operation Supercritical Boiler

Study on coal combustion characteristics in a 350MW supercritical tangentially boiler

Brief Introduction of Calculation Process for Start-up Characteristic of Supercritical Once-through Boiler

Development of Computer Program for Once Through Boiler Start Up Simulation

Character and Analysis on the start-up system design of Ultra-supercritical Boiler

A Study of the Water Swell in Supercritical Once through Boilers During Start up

Numerical Simulation of Combustion Process for an 1000MW Ultra-Supercritical Boiler at Different Air Distribution Proportions

Study on the Dynamic Characteristics of a 600MW Supercritical Once-Through Boiler

Modeling and Simulation of the Long-term Dynamic Characteristics of a Supercritical Once-through Boiler

Study on Dynamic Characteristics of a 600MW Ultra-Supercritical Double-Reheat Boiler

Boiler Start-up Process Simulation Software with Mixed-language Programming

Modeling of a 300 MW Circulating Fluidized Bed Boiler

Simulation of Dynamic Characteristics of Supercritical Boiler Based on Coupling Model of Combustion and Hydrodynamics

Modeling and Simulation for 440 T/h CFB Boiler Steam/Water System

Heat Transfer in Furnace of 1 000 MW Coal-fired Unit under Different Load Conditions

DESIGN AND OPERATION OF SUPERCRITICAL PRESSURE ONCE - THROUGH BOILER START-UP SYSTEM

Dynamic Simulation of MFT and BT Processes on a 660 MW Ultra-Supercritical Circulating Fluidized Bed Boiler

Integrated Numerical Model for Ultra/Supercritical CFB Boilers

Study on Nonlinear Control Model of Supercritical (Ultra Supercritical) Circulating Fluidized Bed Unit

Thermodynamic Analysis of a 660 MW Ultra-Supercritical CFB Boiler Unit