Abstract:A large-scale supercritical circulating fluidized bed (SCCFB) boiler, which generates steam with supercritical pressure and high temperature, overcomes the major shortcoming of the ambient circulating fluidized bed (ACFB) boiler whose thermal efficiency is not sufficient high, and inherits ACFB's advantage in environmental protection. Its investment and operation cost for desulphurization and low NOX emission guaranteed is less than that of pulverized coal fired (PC) boiler equipped with flue gas desulphurization (FGD) and selected catalytic reaction (SCR). Thus SCCFB is regarded as the next generation clean coal technology.Supported by Chinese Ministry of Science and Technology (MOST), the pre-feasibility study of an 800MWe SCCFB boiler was conducted. The designed fuel was high sulfur bituminous coal. Based on the experience of supercritical pressure PC boiler, once reheat and sliding pressure were adopted, with 604 degrees C and 26.17MPa for fresh steam and 604 degrees C for reheat steam. The boiler was of single furnace with pant legs, and the membrane water walls were composed of once-through vertical smooth tubes with throttle but intermediate mixing. It is found that the thickness of 8mm was safe to prevent the tubes From erosion at various load conditions because of the rather high mass flow rates. The combustion system consisted of 6 thermal-insulated cyclones. 6 water-cooled mechanical distribution valves and 6 external heat exchangers (EHEs). An internal start-tip system with recirlculating pumps was also suggested. The boiler efficiency was about 93% at B-MCR, and emissions of NOX and CO are kept lower than 200mg/Nm(3) and 100mg/Nm(3), respectively. Hydrodynamics performance and material balance at full and partial loads were predicted with a mathematical model. The simulation results confirm the correctness of the design with vertical water wall of the furnace.

Study on Nonlinear Control Model of Supercritical (Ultra Supercritical) Circulating Fluidized Bed Unit

Predictive Control and Economic Performance Optimization of CFBB Combustion Process

Research on control system of 600 MW supercritical circulating fluidized bed boiler

Development of a Supercritical and an Ultra-Supercritical Circulating Fluidized Bed Boiler

On the Flexible Operation of Supercritical Circulating Fluidized Bed: Burning Carbon Based Decentralized Active Disturbance Rejection Control

Research and Application of Supercritical and Ultra-supercritical Circulating Fluidized Bed Boiler Technology

Dynamic Modeling of Key Operating Parameters for Supercritical Circulating Fluidized Bed Units based on Data-Knowledge-Driven Method

Conceptual Design Of An 800mwe Supercritical Pressure Circulating Fluidized Bed Boiler And Its Performance Prediction

A Comprehensive CFD Combustion Model for Supercritical CFB Boilers

Development and validation of a dynamic flowsheet model for a 350 MWe supercritical circulating fluidized bed boiler

Design and Research on a 600MWe Supercritical Circulating Fluidized Bed Boiler

Research on Waterwall Dynamic Characteristics of a 600 MW Supercritical Circulating Fluidized Bed Boiler

Design and Development of a 660 MW High Efficiency Ultrasupercritical Double-furnace CFB Boiler

Closed-Loop Combustion Optimization Control With Applications to an Ultra-Supercritical Coal-Fired Boiler

MLD–MPC for Ultra-Supercritical Circulating Fluidized Bed Boiler Unit Using Subspace Identification

STUDY ON COORDINATED CONTROL SYSTEM OF UNITS EQUIPPED WITH CFB BOILER

Thermal–hydraulic Calculation and Analysis of a 600 MW Supercritical Circulating Fluidized Bed Boiler with Annular Furnace

Dynamic Model for Subcritical Circulating Fluidized Bed Boiler-Turbine Units Operated in a Wide-Load Range

Modeling study on the dynamic characteristics in the full-loop of a 350 MW supercritical CFB boiler under load regulation

Novel Coordinated Control Method with Coal-Quality Correction of Circulating Field Bed Boiler

Dynamic performance analysis and control strategy optimization for supercritical coal-fired boiler: A dynamic simulation