Abstract:Proceedings of the Institution of Mechanical Engineers, Part L: Journal of Materials: Design and Applications, Ahead of Print. After pneumatic shot peening, compressive residual stress is induced on the surface of the target, which will improve the fatigue life. During the process, surface roughness is also induced, which may reduce the fatigue life. To achieve the optimum compressive residual stress with the smallest surface roughness, the formation mechanism of the residual stress field and the surface topography are revealed. Then, pneumatic shot peening is simulated by using a discrete element method–finite element method coupled model. Based on the effects of four variables (the incident angle θ, the initial shot velocity v0, the shot radius R) and the mass flow rate rm on five parameters (the equivalent plastic strain, the equivalent stress, the surface compressive residual stress, the maximum compressive residual stress), the surface roughness is investigated. The results show that it induces a residual elastic–plastic strain after the impact of a single shot, which can form a crater and a hemispherical residual stress field. After the impact of many random shots, scattered craters connect with each other, therewith a rough and continuous surface topography is formed. Scattered residual stress fields couple with each other, and a constant residual stress layer with the compressive residual stress in the surface and the tensile residual stress in the subsurface are formed. All five parameters are determined by the residual elastic–plastic strain, which increases as the augment of the normal impact velocity, the shot mass, and the coverage rate. Along with the increase of θ and rm, these five parameters firstly increase and then decrease; with the increase of v0 and R, these five parameters increase. Therefore, reasonable values of θ, v0, R, and rm should be chosen to obtain the optimum compressive residual stress with as small surface roughness as possible.

Prediction of residual stress relaxations in shot-peened specimens and its application for the rotor disc assessment

Prediction of residual stress relaxations in shot-peened specimens for fatigue crack growth

Prediction of fatigue crack growth and residual stress relaxations in shot-peened material

Depth-sensing Indentation Measurement and Finite Element Analysis of Residual Stress Field Near Fatigue Crack Tip

Fatigue Crack Propagation Analysis in an Aero-Engine Turbine Disc Using Computational Methods and Spin Test

Prediction of the effect of shot peening residual stress on fretting fatigue behaviour

Prediction of 3D Small Fatigue Crack Propagation in Shot-Peened Specimens

Fatigue crack growth prediction for shot-peened steel considering residual stress relaxation

An analytical model for predicting residual stress in shot peening with strain energy method

Studies on residual stress and surface topography after pneumatic shot peening using discrete element method–finite element method coupled model

Effect of shot peening parameters on fretting fatigue lifetime

Fatigue life prediction model for shot-peened laser powder bed fused 304L steel considering residual stress relaxation and defect distribution

Prediction of fatigue crack propagation behavior of AA2524 after laser shot peening

Numerical Simulation of Residual Stress Field Induced by Ultrasonic Shot Peening

Measurement and Identified Prediction Equation for Residual Stress Distribution in Aluminum Alloy A5052 under Various Pneumatic Shot Peening Conditions

Investigation of residual stress, stress relaxation and work hardening effects induced by shot peening on the fatigue life of AA 6005-T6 aluminum alloy

Investigation of the effects of shot overlap and rigid body assumptions on surface layer characteristics in shot peening simulation

Probabilistic fatigue life prediction and reliability assessment of a high pressure turbine disc considering load variations

Deformation measurement and simulation of Ti–6Al–4V blades induced by shot peening process

Study of the shot peening surface roughness in fretting

Initial Residual Stress Measurement Based on Piecewise Calculation Methods for Predicting Machining Deformation of Aeronautical Monolithic Components