Abstract:Developing effective strategies for enhancing the damage tolerance of laser powder bed fusion (LPBF) components remains a formidable challenge in the disruptive additive manufacturing field. The typical shot-peening (SP) is a promising and efficient post-treatment procedure owing to its capability to introduce compressive residual stress, enhance the surface integrity, shrinkage the subsurface lack-of-fusion (LoF) defects of LPBF components. However, there is still a significant gap in understanding the appropriate utilization of the SP procedure to enhance fatigue performance, hindering its full potential in practical applications. This study systematically investigated the influence of surface coverage (150 %, 300 %, and 450 %) on surface characteristics, subsurface characteristics, and mechanical properties of LPBF 304L austenitic steel. Though evaluating the feasibility of severe shot peening and observing post-deformed microstructures, the process-microstructure-performance relationship of shot-peened LPBF austenitic steel was preliminarily established for the first time. The results indicated that increasing surface coverage up to a threshold (300 % in this work) could effectively enhance the strength and fatigue performance without significantly sacrificing ductility, primarily attributed to the increased gradient strain generated by the gradient deformation structures as well as the shrinkage of detrimental near-the-surface defects. The excessive surface coverage may be detrimental to ductility and fatigue performance, as it directly increases the severe plastic deformation and near-saturated micro-defects in the gradient deformation layer, substantially weakening the strain gradient's capability to accommodate dislocation flow during deformation. The findings suggested careful selection of shot peening coverage to balance enhanced mechanical properties and minimal introduction of detrimental defects.

Fatigue life prediction model for shot-peened laser powder bed fused 304L steel considering residual stress relaxation and defect distribution

Revealing the relationship between the shot type and fatigue performance of laser powder bed fused 304L steel following shot peening

Fatigue life evaluation and cellular substructure role of laser powder bed fused 304 L steel based on dissipative deformation mechanisms

Fatigue crack growth prediction for shot-peened steel considering residual stress relaxation

An Approach to Estimate the Low Cycle Fatigue Probabilistic Curves of PBF-LB/M 316L Steel from Small Size Datasets Using the Remora Optimization Algorithm

Shot peening coverage effect on laser powder bed fused steel

Effect of Surface Modification on the High Temperature Low Cycle Fatigue Performance of LPBF 316L Austenitic Steel

Fatigue life prediction for LPBF-fabricated Ti-6Al-4V up to very-high-cycle regime based on continuum damage mechanics incorporating effect of defects

Fatigue life prediction of 316L stainless steel weld joint including the role of residual stress and its evolution: Experimental and modelling

Prediction of fatigue crack propagation behavior of AA2524 after laser shot peening

Effect of scanning speed on fatigue behavior of 316L stainless steel fabricated by laser powder bed fusion

A New Empirical Life Prediction Model For 9-12%Cr Steels Under Low Cycle Fatigue And Creep Fatigue Interaction Loadings

Prediction of the effect of shot peening residual stress on fretting fatigue behaviour

Effect of shot peening parameters on fretting fatigue lifetime

The Effect of Severe Shot Peening on Fatigue Life of Laser Powder Bed Fusion Manufactured 316L Stainless Steel

The Synergetic Effects of Shot Peening and Laser-Shot Peening on the Microstructural Evolution and Fatigue Performance of a Medium Carbon Steel

Prediction of fatigue crack growth and residual stress relaxations in shot-peened material

Fatigue life prediction of additively manufactured AlSi10Mg based on surface roughness and residual stress

An analytical model for predicting residual stress in shot peening with strain energy method

A Fatigue Life Prediction Approach for Resistance Spot Welded Joints with Consideration of the Stress Ratio Effect

Residual Stress Field Induced by Laser Peening: a Finite Element Analysis