Abstract:A phase-field description of brittle fracture is employed in the reported four-point bending analyses of monolithic and laminated glass plates. Our aims are: (i) to compare different phase-field fracture formulations applied to thin glass plates, (ii) to assess the consequences of the dimensional reduction of the problem and mesh density and refinement, and (iii) to validate for quasi-static loading the time-/temperature-dependent material properties we derived recently for two commonly used polymer foils made of polyvinyl butyral or ethylene-vinyl acetate. As the nonlinear response prior to fracture, typical of the widely used Bourdin–Francfort–Marigo model, can lead to a significant overestimation of the response of thin plates under bending, the numerical study investigates two additional phase-field fracture models providing the linear elastic phase of the stress-strain diagram. The typical values of the critical fracture energy and tensile strength of glass lead to a phase-field length-scale parameter that is challenging to resolve in the numerical simulations. Therefore, we show how to determine the fracture energy concerning the applied dimensional reduction and the value of the length-scale parameter relative to the thickness of the plate. The comparison shows that the phase-field models provide very good agreement with the measured stresses and resistance of laminated glass, despite the fact that only one/two cracks are localised using the quasi-static analysis, whereas multiple cracks evolve during the experiment. It was also observed that the stiffness and resistance of the partially fractured laminated glass can be well approximated using a 2D plane-stress model with initially predefined cracks, which provides a better estimation than the one-glass-layer limit.

Indentation fracture and toughness assessment for thin optical coatings on glass

Statistical Analysis of Fracture Toughness of Soda-Lime Glass Determined by Indentation

Evaluation and Comparison of Fracture Toughness of Glass Fibre Reinforce Composites

The Competing Effect of Initial Crack Depth Versus Chemical Strengthening Parameters on Apparent Fracture Toughness of Sodium Aluminosilicate Glass

Indentation toughness of ceramics: a statistical analysis

Assessment of sub-micron subsurface damage in glass

Scratch-induced micro-fracture behaviour and translational failure of glass: An experimental and numerical study

Nondestructively determining local strength and residual stress of glass by Hertzian indentation

Lateral cracks in soda-lime glass under the threshold load due to the interaction of indentations

Quantification of degradation of nanomechanical properties around a static damage

Notch fracture toughness of glasses: Rate, age and geometry dependence

Toughness measurement of thin films based on circumferential cracks induced at conical indentation

Assessment on flexural performance of monolithic glass considering spatial and depth characteristics of scratches

Statistical properties of indentation toughness of ceramics

Surface damage resistance and yielding of chemically strengthened silicate glasses: From normal indentation to scratch loading

Roughness of oxide glass subcritical fracture surfaces

Evaluation by Indentation of Fracture Toughness of Ceramic Materials

Fracture mechanical behavior of polymers: 1. Amorphous glassy state

Phase-Field Fracture Modelling of Thin Monolithic and Laminated Glass Plates under Quasi-Static Bending

Indentation of Coatings at micro/nano scale: Crack formation and deflection

Micromechanical characterization of zirconia and silicon nitride ceramics using indentation and scratch methods