Abstract:This paper investigated the preparation method and the dispersion behaviour of Modified Carbon Nanotube-fiber Reinforcements (MCNF), the change laws and the effect mechanisms of dynamic compressive strength of MCNF concretes. Electrophoresis method was used to prepare MCNF and its interfacial shear performance was tested by interfacial shear strength (IFSS) test. In addition, the dispersion behavior of MCNF in simulated concrete solution was verified by turbidity method. Split Hopkinson Pressure Bar (SHPB), Scanning Electron Microscope (SEM) and Mercury Intrusion Porosimetry (MIP) tests were carried on concrete samples with different volume fractions (0%, 0.1%, 0.2%, 0.3%, 0.4%) of MCNF. The results show that carbon nanotubes are easier to deposit to the negative electrode, and the higher the content of polycarboxylate superplasticizer, the more obvious the dispersity of MCNF in alkaline environment. The dynamic compressive strength of MCNF concrete was 14.0–35.5% higher than that of untreated concrete, and reached the maximum when the MCNF content was about 0.3%. The MCNF was wrapped in concrete matrix and promoted hydration reaction of interface between cement and MCNF from microscopic observation. The addition of MCNF could increase the porosity. The volume percentage of ≥ 100 nm pore decreased first and then increased. Reasons for the improvement strength of MCNF concrete is that the bridging effect is stronger with the increase of MCNF content (≤ 0.3%) and limited when the MCNF content is equal to 0.4%. MCNF concrete could be used in actual engineering with high requirements for dynamic load.

Experimental Study on Dynamic Compression of Nylon Reinforced Concrete

Experimental Studies on Concrete Filled Steel Tubes under High Strain Rate Loading

High-strain Rate Compressive Behavior of CFRP Confined Concrete: Large Diameter SHPB Tests

Experimental Investigation on the Dynamic Compressive Behavior of Rubberized Concrete

Experimental investigation on the dynamic tensile behavior of graded steel-fiber RPC

Compressive Impact Tests of Lightweight Concrete with 155-Mm-diameter Spilt Hopkinson Pressure Bar

Experimental Study on the Spalling Strength of Fiber Reactive Powder Concrete

Quasi-static Testing and Networked Pseudo-Dynamic Testing on Fiber Reinforced Plastic Retrofitted Reinforcement Concrete Short Columns of Bridge

Dynamic Behavior of Reactive Powder Concrete in Split Hopkinson Pressure Bar Testing

High-strain Rate Compressive Behavior of Concrete Made with Substituted Coarse Aggregates: Recycled Crushed Concrete and Clay Bricks

Effect of Natural Fibre Reinforced Polymers on Confined Compressive Strength of Concrete

Dynamic tensile strength tests for steel fiber reinforced concrete

Experimental Study of Dynamic Tensile Strength of Steel-Fiber-Reinforced Self-Compacting Concrete Using Modified Hopkinson Bar

An Experimental Study of Dynamic Compression Performance of Self-Compacting Concrete

Experimental Study on Dynamic Splitting Characteristics of Carbon Fiber Reinforced Concrete

Research on Compressive Impact Dynamic Behavior and Constitutive Model of Polypropylene Fiber Reinforced Concrete

Experimental study on concrete under dynamic tensile loading

Study of dynamic behavior of concrete under splitting tensile tests based on mesomechanics

Study on Dynamic Properties of Plain Concrete under Uniaxial Compression and Its Constitutive Relation

Experimental study of impact mechanical and microstructural properties of modified carbon fiber reinforced concrete

An experimental investigation of pre-loading effects on the dynamic behaviour of concrete