Abstract:The proton-exchange membrane fuel cell (PEMFC) bipolar plate serpentine flow channel U-shaped region is prone to the accumulation effect, which poses serious difficulties for fuel cell water management. As a result, a deep understanding of water transport in the U-shaped region is essential to improve the fuel cell performance. Under this direction, in this work, the impact of the different microstructure parameters and initial conditions on water transport in the U-shaped region was compared with and without microstructure using the volume of the fluid method. On top of that, the velocity field distribution in the X-direction and the pressure drop distribution in the flow channel were also analyzed. From the acquired results, it was demonstrated that due to the secondary flow caused by the bending property of the microstructure, the droplet movement time in the U-shaped region was significantly shortened after the microstructure was added in the U-shaped region. The initial conditions strongly affected the droplet motion, and a larger contact angle enhanced the wall hydrophobicity to facilitate the droplet discharge. An increase in the droplet diameter led also to a rise in the windward area and shear force, which shortened droplet discharge time. Interestingly, if the waveform microstructure has too-large crests, gullies will be created that will impede the droplet motion and increase the amplitude of the droplet oscillation, resulting in excessive pressure drop in the flow channel. A too-large period led to increased droplet momentum loss, whereas a short period reduced the wall contact angle, which is not conducive to drainage. The microstructure spacing significantly affected the droplet motion, and the reduced spacing increased the airflow diffusion effect to accelerate the flow rate. The main focus of this work was led on the application of the microstructure in a U-shaped region of the serpentine flow channel, which is of great specific significance for droplet removal inside the flow channel.

Study of Micro Direct Methanol Fuel Cell Plate Configuration

Experimental Investigations of the Anode Flow Field of A Micro Direct Methanol Fuel Cell

Design, Optimization and Microfabrication of a Micro-Direct Methanol Fuel Cell with Microblocks in Anode Structure

Electrochemical Behaviors of Metal Bipolar Plate in Simulated DMAFC Environment

Evaluation of structural aspects and operation environments on the performance of passive micro direct methanol fuel cell

Parameters research of the anode flow field of a micro direct methanol fuel cell

Design and Fabrication of a Polymer-Based Micro Direct Methanol Fuel Cell

A Silicon-Based Micro Direct Methanol Fuel Cell with Microblocks in Anode Structure

The function of microporous layers and the interaction between the anode and cathode in DMFCs. Part I: The double roles of microporous layers in DMFCs

An exploration of the solution of direct methanol fuel cell cost effectiveness

A micro-direct methanol fuel cell stack with optimized design and microfabrication

An Air-Breathing Micro Direct Methanol Fuel Cell Stack Employing a Single Shared Anode Using Silicon Microfabrication Technologies

Effect of Anode Flow Pattern Design on the Performance of Micro Air-Breathing DMFC

Effects of Microstructure on Water Removal in the U-Shaped Region of PEMFC Serpentine Flow Channel

Design and fabrication of a silicon-based micro direct methanol fuel cell stack

Micro direct methanol fuel cell: functional components, supplies management, packaging technology and application

Testing Study of Different Flow Direction and Structure for Air-Cooled Proton Exchange Membrane Fuel Cell

Effect of the Microporous Layer Structure and Hydrophobicity on the Performance of Direct Methanol Fuel Cells

Design, Fabrication and Testing of a Silicon-Based Air-Breathing Micro Direct Methanol Fuel Cell

Micro-electroforming metallic bipolar electrodes for mini-DMFC stacks

A Silicon-Based Micro Direct Methanol Fuel Cell Stack with Compact Structure and PDMS Packaging