Abstract:Two Cu/SiO2 mesoporous materials (Cu-MCM-41) were synthesized, one by the ion exchange (IE) post-synthesis method and the other, by the sol-gel (SG) method by co-precipitation of copper and silica (Cu-MCM-41) in the cetyltrimethylammonium bromide (CTAB) presence. The effects of the synthesis method on these materials were analyzed. They were characterized by XRD, N2 adsorption-desorption, TEM, DRUV–vis, FTIR, TPR, XPS, and FTIR with both, CO and pyridine adsorbed. Using the SG method, an MCM-41 material with a uniform mesoporous structure (Dp ≈ 35 Å), and a specific surface area (SBET) of 800 m2.g-1, was obtained. With the IE method and due to the partial collapse of the SiO2-MCM-41 mesoporous structure used as support, a material with a lower SBET (560 m2.g-1) was produced. The Cu in the SG synthesized material was mainly constituted by SiO-[CuO]n-CuOSi polymeric species and small CuO agglomerates. On the other hand, in the IE material, the copper was in the form of isolated SiO–Cu–OSi monomers, SiO–Cu–O–Cu–OSi dimers, and only a low proportion of SiO-[CuO]n-CuOSi oligomers. The catalytic activity of both materials was tested against the 2-propanol (2-PrOH) dehydrogenation in the gas phase. The reaction rate of the IE synthesized material was an order of magnitude higher than that prepared by the SG method. This behavior was attributed to the presence of SiO–Cu+ pair formed by the reduction of SiO–Cu–O–Cu–OSi dimmers present in the material prepared by IE; in contrast with the CuO aggregates obtained by the SG method.

Effect of Copper Content on the Direct Process of Organosilane Synthesis from Silicon and Methyl Chloride

Influence factors of hydrolysis and condensation of organic silicon oxygen alkyl

CONVERSION AND UTILIZATION OF BYPRODUCTS IN DIRECT SYNTHESIS OF METHYLCHLOROSILANES

Effect Of Cucl Particle Size On The Reduction Reaction By Silicon In Preparation Of Contact Mass Used For Methylchlorosilane Synthesis

A Bi-component Cu Catalyst for the Direct Synthesis of Methylchlorosilane from Silicon and Methyl Chloride

Process characteristics of Cu-based catalyst in direct synthesis of methylchlorosilanes

Selective Hydrogenation of Dimethyl Maleate to Tetrahydrofuran over Cu/SiO2 Catalyst: Effect of Cu+ on the Catalytic Performance

Conversion of Methyltrichlorosilane in Stirred Bed Reactor by Methylalumminumchloride Method

Siloxane-Mediated Ethylene Oligomerization with Iron-Based Catalysts: Retarding the Polymer Formation

Surface Morphology and Catalytic Activity of the Contact Mass in Organosilane Synthesis

Effect and Role of Al Addition in the Direct Synthesis Reaction of Methylchlorosilane Monomer

Modification of CuCl catalyst used in the direct synthesis reaction of methyl chlorosilane monomer

Study of the Effect of Zn, Sn, and Pb Additives on the Direct Mechanochemical Synthesis of Tetramethoxysilane in the Presence of CuCl and CuO Catalysts

Preparation of highly active CuCl catalyst for the direct process of methylchlorosilane production

Synthesis of methylchlorosilane by direct process and its gas chromatographic analysis

Synthesis of Cu/SiO2(MCM-41) mesostructured catalysts. Effect of the preparation method on the textural properties and chemical structure

Effect of synthesis parameters on the chromium content and catalytic activities of mesoporous Cr-MSU-x prepared under acidic conditions

Selective Synthesis of Triethoxysilane and Tetraethoxysilane through Direct Reaction between Ethanol and Silicon Catalyzed by CuCl and Metallic Cu0 Nanoparticles in Fixed-bed Reactor

Promoter Effects of Zn and Sn in the Direct Synthesis of Methylchlorosilanes

The Influence of Copper Particle Dispersion in Cu/SiO 2 Catalysts on the Hydrogenation Synthesis of Ethylene Glycol

Copper-Catalyzed Desymmetrization of Prochiral Silanediols to Silicon-Stereogenic Silanols