Abstract:The preparation of β-hemihydrate gypsum is an important approach for large-scale utilization of phosphogypsum (PG) because of the simple production technology by calcination. However, the dehydration behaviour and impurity change during the transformation of PG to β-hemihydrate gypsum at low temperatures are unclear. In this study, the dehydration of PG at different temperatures was investigated by a calcination test and in-situ X-ray diffraction analysis. The variation in crystal morphology and structure of PG was clarified using scanning electron microscopy and Materials Studio software. Furthermore, the change of impurity was analyzed by energy-dispersive spectroscopy, Fourier transform infrared spectroscopy and X-ray photoelectron spectroscopy measurements. The results show that the dehydration of PG to β-hemihydrate gypsum depends on calcination temperature and time. Moreover, an increase in the calcination temperature could accelerate the dehydration of PG and shorten the dehydration time; meanwhile increasing the calcination time or calcination temperature could make a part of β-hemihydrate gypsum further dehydrate to anhydrite. The morphology and elemental distribution of PG did not dramatically change during calcination, but the grain size decreased and the elemental distribution density increased. It should be noted that the calcination did not decrease the phosphorus and fluorine contents in PG at 120 °C, whereas the contents increased due to the removal of crystal water. The phosphorus impurity form transformed from CaHPO4·2H2O and Ca(H2PO4)2·H2O to CaHPO4 and Ca(H2PO4)2, respectively. Therefore, the calcination could not remove the phosphorus and fluorine from PG, and pretreatment is required to reduce the adverse effects of impurities in the industrial production of β-hemihydrate gypsum.

Technical Study on Impurities Removal and Dehydration of Phosphogypsum by Hydrothermal Method

Study on Strengthening the Crystallization Process of Removing F and P from Phosphogypsum Produced by Dihydrate–Hemihydrate Wet Process

The study on the effect of flotation purification on the performance of α-hemihydrate gypsum prepared from phosphogypsum

Efficient removal of impurities from phosphogypsum during preparation of α-hemihydrate gypsum

Study of Semi-Dry High Target Solidification/Stabilization of Harmful Impurities in Phosphogypsum by Modification

Dehydration behaviour and impurity change of phosphogypsum during calcination

Efficient precipitation of soluble phosphorus impurities in the recycling of phosphogypsum to produce hemihydrate gypsum

Novel Synergistic Process of Impurities Extraction and Phophogypsum Crystallization Control in Wet-Process Phosphoric Acid

Comparative analysis of colloid-mechanical microenvironments on the efficient purification of phosphogypsum

Study on Preparation of High-Strength Gypsum by FGD Gypsum

Study on Mechanisms for Improving Quality and Whiteness of Phosphogypsum Based on Process Mineralogy Analysis

Gradient removal of Si and P impurities from phosphogypsum and preparation of anhydrous calcium sulfate

Efficient extraction of impurities from phosphogypsum during crystal regulation of α‐hemihydrate gypsum

Investigating the novel process for thorough removal of eutectic phosphate impurities from phosphogypsum

Study on the Kinetics of Hydration Transformation from Hemihydrate Phosphogypsum to Dihydrate Phosphogypsum in Simulated Wet Process Phosphoric Acid

Simultaneous removal of phosphorus and organic contaminants from phosphogypsum using hydrothermal method for gypsum resource regeneration

Retarding effect of impurities on the transformation kinetics of FGD gypsum to α-calcium sulfate hemihydrate under atmospheric and hydrothermal conditions

Review of the State of Impurity Occurrences and Impurity Removal Technology in Phosphogypsum

Deep removal of phosphorus and synchronous preparation of high-strength gypsum from phosphogypsum by crystal modification in NaCl-HCl solutions

Hydration reaction and microstructural characteristics of hemihydrate phosphogypsum with variable pH