Abstract:High-performance polysilicon (P-Si) is fundamental as a resource for manufacturing semiconductor devices with high photoelectric properties. However, experimentally characterizing the solidification process in detail has been difficult on account of the extremely rapid cooling rate and limited available characterization methods. Therefore, this study used molecular dynamics (MD) to investigate Si crystallization behavior through directional solidification at different cooling rates. The entire system was first analyzed in terms of energy and radial distribution function, after which the microstructural evolution was characterized by visualization. Results indicated that the cooling rate significantly affected the directional solidification of Si, and an excessively high cooling rate resulted in a decrease in the long-range order of the system. At the same cooling rate, the crystallization rates of (1 0 0), (1 1 0), and (1 1 1) crystal faces followed a descending order. The configurations of the S-L interface with different crystal faces were distinct. Specifically, while the atom numbers of defect structures that were formed in systems of (1 0 0) and (1 1 0) crystal faces were few, those formed in the (1 1 1) crystal face were more. It was difficult for the (1 0 0) crystal face to form dislocations regardless of the crystallization degree at different cooling rates, and the (1 1 0) crystal face only formed a few dislocations at high cooling rates. Dislocations formed at all cooling rates during the directional solidification of the (1 1 1) crystal face, and there was a weak correlation between the number of dislocations and cooling rates. Twinning mainly occurred during the solidification process of the (1 1 1) crystal face, and there was no obvious linear relation between its number and the cooling rate. Moreover, when high-energy dislocations occurred more often, the system stability decreased. Overall, this work will be helpful to understand the commonness and difference in directional solidification of Si with different crystal faces at different cooling rates.

An optical microscopy study of dislocations in multicrystalline silicon grown by directional solidification method

(Invited) Defects in Cast-Mono Crystalline Silicon

Distribution and propagation of dislocation defects in quasi-single crystalline silicon ingots cast by the directional solidification method

Preparation, microstructure and dislocation of solar-grade multicrystalline silicon by directional solidification from metallurgical-grade silicon

The dislocation distribution characteristics of a multi-crystalline silicon ingot and its impact on the cell efficiency

Multicrystalline Informatics Applied to Multicrystalline Silicon for Unraveling The Microscopic Root Cause of Dislocation Generation

Optical anisotropy and strain-induced birefringence in dislocation-free silicon single crystals

Optical Anisotropy in Dislocation-Free Silicon Single Crystals

Characteristics of Thermal Stress Evolution During the Cooling Stage of Multicrystalline Silicon

Analysis of Structural Development and Defects during the Anisotropic Growth of Silicon

Influence of Furnace Design on the Thermal Stress During Directional Solidification of Multicrystalline Silicon

A Modified Cooling Process in Directional Solidification of Multicrystalline Silicon

Study of Effects of Varying Parameters on the Dislocation Density in 200 Mm Sic Bulk Growth

Controlling Dislocation Gliding and Propagation in Quasi-Single Crystalline Silicon by Using <110>-Oriented Seeds

Structure Characteristic and Defects Controlling in Cold Crucible Directional Solidification of Multicrystalline Silicon for Solar cells

Electrical/Optical Activities of Grain Boundaries in Multicrystalline Si

Dislocation determination and quality control of industrial casting monocrystalline silicon

Gedanken experiment on point defects in unidirectional solidified single crystalline silicon with no dislocations

General Molecular Dynamics Approach to Understand the Mechanical Anisotropy of Monocrystalline Silicon under the Nanoscale Effects of Point Defect

Effect of Heat Transfer During the Vacuum Directional Solidification Process on the Crystal Quality of Multicrystalline Silicon

Numerical Analysis of the Dislocation Density in Multicrystalline Silicon for Solar Cells by the Vertical Bridgman Process