Abstract:High-performance polysilicon (P-Si) is fundamental as a resource for manufacturing semiconductor devices with high photoelectric properties. However, experimentally characterizing the solidification process in detail has been difficult on account of the extremely rapid cooling rate and limited available characterization methods. Therefore, this study used molecular dynamics (MD) to investigate Si crystallization behavior through directional solidification at different cooling rates. The entire system was first analyzed in terms of energy and radial distribution function, after which the microstructural evolution was characterized by visualization. Results indicated that the cooling rate significantly affected the directional solidification of Si, and an excessively high cooling rate resulted in a decrease in the long-range order of the system. At the same cooling rate, the crystallization rates of (1 0 0), (1 1 0), and (1 1 1) crystal faces followed a descending order. The configurations of the S-L interface with different crystal faces were distinct. Specifically, while the atom numbers of defect structures that were formed in systems of (1 0 0) and (1 1 0) crystal faces were few, those formed in the (1 1 1) crystal face were more. It was difficult for the (1 0 0) crystal face to form dislocations regardless of the crystallization degree at different cooling rates, and the (1 1 0) crystal face only formed a few dislocations at high cooling rates. Dislocations formed at all cooling rates during the directional solidification of the (1 1 1) crystal face, and there was a weak correlation between the number of dislocations and cooling rates. Twinning mainly occurred during the solidification process of the (1 1 1) crystal face, and there was no obvious linear relation between its number and the cooling rate. Moreover, when high-energy dislocations occurred more often, the system stability decreased. Overall, this work will be helpful to understand the commonness and difference in directional solidification of Si with different crystal faces at different cooling rates.

Gedanken experiment on point defects in unidirectional solidified single crystalline silicon with no dislocations

Simulation analysis of point defects in a silicon ingot during a unidirectional solidification process for solar cells

Simulation Analysis of Point Defects in Silicon Ingot During Unidirectional Solidification Process for Solar Cells

Atomistic Investigations of Single-Crystal Silicon with Pre-Existing Defects

MD Simulation and Transport Property Analysis of Silicon in High-Temperature Molten Fluoride Salts Electrolyte

(Invited) Defects in Cast-Mono Crystalline Silicon

Numerical Analysis of the Dislocation Density in Multicrystalline Silicon for Solar Cells by the Vertical Bridgman Process

Study on thermal stress in a silicon ingot during a unidirectional solidification process

Intrinsic point defects in crystalline silicon: Tight-binding molecular dynamics studiesof self-diffusion, interstitial-vacancy recombination, and formation volumes

Impact of Thermal Stress on Intrinsic Point Defect in Czochralski Crystal Growth: Developing a Quantitative Model for Defect Formation and Distribution

Study of Effects of Varying Parameters on the Dislocation Density in 200 Mm Sic Bulk Growth

Influence of Crystal Growth Rate on the Thermal Field in a Directional Solidification Process for Silicon Solar Cells

Numerical analysis of cooling rate dependence on dislocation density in multicrystalline silicon for solar cells

Distribution and propagation of dislocation defects in quasi-single crystalline silicon ingots cast by the directional solidification method

Oxygen and Carbon Precipitation in Multicrystalline Solar Silicon

Grain Boundary Development of Silicon during Directional Solidification: A Phase-Field Study

Analysis of Structural Development and Defects during the Anisotropic Growth of Silicon

Defects in nitrogen-doped multicrystalline silicon

Three-dimensional global analysis of thermal stress and dislocations in a silicon ingot during a unidirectional solidification process with a square crucible

3D Numerical Analysis of the Influence of Material Property of A Crucible on Stress and Dislocation in Multicrystalline Silicon for Solar Cells

Structure Characteristic and Defects Controlling in Cold Crucible Directional Solidification of Multicrystalline Silicon for Solar cells