Abstract:Cu2O and CuO are promising p-type semiconductor materials, which show potential for a variety of applications from photovoltaics to high-Tc superconductors. Atomic layer deposition (ALD) presents an advantageous technique for the growth of copper oxide due to the ability to grow on a variety of substrate materials and geometries with atomic precision in thickness and high uniformity. The work presented here is a comprehensive study on the effect of boost and precursor delivery on the growth of copper oxide films using the same precursor and under the same reactor environment. This is critical to understanding the growth mechanism and properties of ALD grown copper oxide films using the same starting precursor while varying the coreactants. In this study, the deposition of copper oxide is performed using the precursor bis-(dimethylamino-2-propoxide) Cu(II) (Cudmap) and either water or ozone as a coreactant. Keeping the copper precursor pulse constant, CuO films were produced with ozone, while Cu2O films were obtained using water. Through conventional precursor delivery, a saturated growth rate of 0.19 and 0.045 Å/cycle is established using ozone and water as coreagents, respectively. In order to enable more efficient precursor delivery, a vapor boost modification was implemented, which doubled the film growth rate to 0.38 Å/cycle when using ozone, higher than previously reported. While there was no increased growth rate using the vapor boost with water, the growth rate could be doubled to 0.09 Å/cycle by tripling the water dosage. In both cases, the as-deposited films were smoother when implementing a vapor boost and polycrystalline as deposited, which has not been previously observed for Cu2O films grown with Cudmap. From the results here, growth of CuO using ozone is most improved by using a Cudmap vapor boost delivery, indicating Cudmap limited growth, while Cu2O growth is limited by the water dosage.

Preparation and Characterization of Copper Oxide Thin Films Deposited by Filtered Cathodic Vacuum Arc

The characterization of ZrO2 films with different substrate bias voltages

Evaluation of Substrate Material and Cu-doping Effect on the Microstructural and Optical Behavior of ZnO Films

Oxidation of copper during physical sputtering deposition: mechanism, avoidance and utilization

Characteristics of copper oxide films deposited by PBII&D

Study on the electronic and structural properties of oxidized copper films

Cu2O porous nanostructured films fabricated by positive bias sputtering deposition

Epitaxil Electrodeposition Of A Crystalline Metal Oxide Onto Single-Crystalline Silicon

Electrical and optical properties of copper oxide thin films prepared by DC magnetron sputtering

Effect of substrate bias on ta-C films deposited by magnetically enhanced vacuum arc

Study of the structural, optical, electrical and electrochemical properties of copper oxide thin films synthesized by spray pyrolysis

Chemical Vapor Deposition Mechanism of Copper Films on Silicon Substrates

Effect of substrate bias on nanoindentation hardness and microstructure of polycrystalline copper thin films

INFLUENCE OF RF SUBSTRATE BIAS ON SiO2 FILMS PREPARED BY ECR-PECVD

Effects and Mechanism of ITO and ZnO Substrate on Surface Morgraphology and Structural of Electrodeposited Cu2O Thin Films

Oxide phase and conductivity-type of copper oxide thin films deposited by direct current magnetron sputtering

Comprehensive characterization of copper oxide atomic layer deposition using water or ozone with enhanced bis-(dimethylamino-2-propoxide) copper delivery

Atomic layer deposited p-type copper oxide thin films and the associated thin film transistor properties

Preparation and Photoelectric Property of Cuprous Oxide Thin Film with Different Morphologies

Study of the electronic and optical properties of thin films of copper oxides deposited using a low-pressure arc discharge

Investigation of plasma process in deposition of cupric oxide film produced by radio frequency magnetron sputtering