Abstract:Cyclone-fired boilers have gained wide applications due to their ability to burn low ash fusion temperature coals that are unsuitable for pulverized coal (PC) firing. In comparison to PC boilers, cyclone-fired boilers exhibit significantly different aerodynamics and the molten slag layer plays a critical role in the operation of boilers. However, by far there are still lack of CFD models that are able to provide effective guidance to the design and operation of cyclone-fired boilers. In this paper a CFD model that was designed to solve the practical problems of cyclone-fired boilers was developed in which the capture of coal particles by the molten slag layer was considered through a slag layer capture model to remove the captured particles from calculation and release the combustion heat of the remaining combustibles. This model was then employed to investigate the aerodynamics and flue gas recirculation (FGR) optimization design of a 550 MW cyclone-fired boiler. The results demonstrated the highly nonuniform characteristics of furnace aerodynamics of cyclone-fired boilers due to the strong swirling flows created by the cyclones that frequently leads to the formation of localized high temperature zones and severe boiler fouling problems. Thus, it is critical to adapt the FGR design with the nonuniform furnace flow and temperature distributions. The simulation results showed that with the adapted FGR design the high temperature zones in the furnace could be effectively eliminated. This study is instrumental for the design of FGR system of cyclone boilers to avoid the potential severe boiler fouling problems.

An Advanced Model to Assess Fouling and Slagging in Coal Fired Boilers

A MODEL FOR PREDICTING HEAT TRANSFER PROCESS WITH COAL ASH DEPOSITION IN UTILITY BOILERS

An Integrated Theoretical Fouling Model for Convective Heating Surfaces in Coal-Fired Boilers

Flexibly Using Results of CFD and Simplified Heat Transfer Model for Pulverized Coal-Fired Boilers

Ash Fouling Monitoring Dynamic Models of Coal-Fired Utility Boiler's Heat Transfer Surface

Advanced Modeling Approaches for CFD Simulations of Coal Combustion and Gasification

Numerical Investigation on Development of Initial Ash Deposition Layer for a High-Alkali Coal

CFD modelling of velocity distribution in tangential coal-fired flame

Experimental Study on the Influence of Slagging and Fouling for Wall Temperature Distribution

Slagging behavior modeling in coal gasifiers using two-way coupled slag model with CFD

Development of a heat transfer model for the film boiling regime in a fouling layer

Deposition Model of Fouling on Coal-fired Utility Boiler Heating Surfaces

A Dynamic Heat Transfer Model to Estimate the Flue Gas Temperature in the Horizontal Flue of the Coal-Fired Utility Boiler

Numerical investigations on the aerodynamics and flue gas recirculation of cyclone-fired coal boiler

Modeling of a Front Wall Fired Utility Boiler for Different Operating Conditions

Removal Model of Fouling on Coal-fired Utility Boilers' Heating Surface

Modeling of Multiphase Reaction and Slag Flow in Single-Burner Coal Water Slurry Gasifier

Dem Simulation and Fractal Analysis of Particulate Fouling on Coal-Fired Utility Boilers' Heating Surfaces

Development of a Mechanistic Fouling Model for Predicting Deposit Formation in a Woodchip-Fired Grate Boiler

Monitoring Model for Ash Fouling on Semi-radiation Heating Surface of a 600 MW Supercritical Boiler

Development of a Comprehensive Model for Evaluating Slagging Characteristics in the Co-Combustion of Coal and Biomass