Abstract:As a renewable energy source with zero CO2 emission, biomass has a good application potential in partially replacing fossil fuels for power generation. However, biomass fuels generally contain high content of alkali metal components that easily precipitate and condense to form a viscous initial deposition layer on the heating surface during combustion. Capture of fly ash by viscous surface is thus enhanced, resulting in further severe slagging in the biomass-fired boiler. Aiming at these problems, the adhesion characteristics of the initial deposition layer in the mid-temperature superheater of biomass boiler has been calculated using FactSage software. Combined with the critical velocity model, an integrated model of slagging considering KCl condensation and fly ash viscous capture is established. The user-defined function (UDF) is employed with ANSYS FLUENT software to simulate the fouling behavior of the heating surface of the mid-temperature superheater of biomass boiler, and field sampling results are used for model validation. The results show that the deposition rate in the mid-temperature superheater is consistent with the sampling results. The increase of wall temperature has little effect on the ash impaction efficiency, but the inhibition of KCl condensation leads to fewer deposition. The change of flue gas inlet velocity affects the condensation and impaction efficiency. The impaction efficiency of large particles (50, 80 μm) increases with the increase of flue gas velocity, while the small particles of 10 μm are more easily captured by the viscous wall, resulting in higher deposition efficiency. Under a same gas inlet velocity, the fly ash particles with diameter of 50 μm and 80 μm dominate the deposition. Overall, the contribution to slagging of mid-temperature superheater by alkali gaseous condensation is significant. The mass of KCl direct condensation accounts for 5.41% of the total deposition mass, while the mass of fly ash viscous capture accounts for 19.24%. The proposed model is suitable for predicting ash deposition and fouling on mid-temperature heating surface (about 700 ℃) represented by a mid-temperature superheater of a biomass boiler.

Development of a Comprehensive Model for Evaluating Slagging Characteristics in the Co-Combustion of Coal and Biomass

Behavior of Slagging Deposits During Coal and Biomass Co-combustion in a 300 Kw Down-Fired Furnace

Evaluation of slagging characteristics for microalgae and lignocellulose: A comparison of aggregative index and model

Mechanistic Studies on the Slagging Propensity in Low-Rank Coal Combustion

Review on Slagging Evaluation Methods of Biomass Fuel Combustion

Grey Clustering Prediction for Slagging Potential of Coal Blends Combustion

Slagging inhibition through co-firing of coal gangue and high sodium coal: An experimental and modelling study

Study on the slagging tendency estimation of biomass fuel combustion with different additives and pretreatment processes

Fusion Property Prediction and Mineral Reaction Mechanism of Coal/biomass Ash Blends Upon In-Situ Tests in the Gasification Process

A critical review of ash slagging mechanisms and viscosity measurement for low-rank coal and bio-slags

Modelling of Fly Ash Viscous Deposition and Slagging Prediction of Biomass-fired Boiler

MODELLING STUDY ON THE EFFECT OF ASH FUSION CHARACTERISTICS ON THE BIOMASS SLAGGING BEHAVIOR

Prediction Model of Slagging Characteristics of Large Capacity Coal Fired Boiler

Slagging Propensity Prediction Method Based On Calphad

Investigation of the Slagging Characteristics During Co-Combustion of Shenhua Coal and Corn Stalk: Effect of Deposition Surface

Application of Different Combustion Models for Simulating the Co-combustion of Sludge with Coal in a 100 MW Tangentially Coal-Fired Utility Boiler

Reduced Pollutant Emissions and Slagging Rate of Biomass Pellet Combustion by Optimizing the Multilayer Distribution of Secondary Air

Simulation of Alkali Gaseous Condensation and Fly Ash Viscous Capture-Induced Dual Slagging on Mid-Temperature Heating Surface of Biomass Boiler

Simulation of Ash Deposit in A Pulverized Coal-Fired Boiler

Slagging behavior modeling in coal gasifiers using two-way coupled slag model with CFD

An Advanced Model to Assess Fouling and Slagging in Coal Fired Boilers