Abstract:Combustion of agricultural residues for heat and electricity production is an efficient way to reduce amount of such waste source and emissions due to inappropriate treatment of them. However, unlike other biomass materials, agricultural residues often have high content of ash and certain ash forming elements with low meting temperatures, resulting in sintering and slagging during combustion processes. It complicates combustion of agricultural residues and restricts further utilization of this renewable energy source. In this work, sintering of a typical agricultural biomass cornstalk and effect of two phosphate additives, Ca(H2PO4)2·H2O and NH4H2PO4, were investigated by a combination of various techniques. Results indicated that the addition of Ca(H2PO4)2·H2O increased the initial melting temperature of cornstalk ash by 64–209 °C. The ash sintering behavior was greatly improved as a result of formation of high melting temperature K–Ca phosphates, Ca9MgK(PO4)7 and Ca2KP3O10 upon addition of the Ca(H2PO4)2·H2O. It is accompanied with reduced generation of low melting temperature K-rich silicates and the formation of large ash aggregates. Addition of NH4H2PO4 increased the initial ash melting temperature by 28–116 °C, but it had slight influence on the cornstalk ash sintering characteristics. The analysis revealed that, although the addition of NH4H2PO4 resulted in the formation of high melting temperature K2CaP2O7, certain amount of K phosphates and silicates eutectics were still formed, initiating and promoting sintering of ash from mixture of cornstalk and NH4H2PO4. Reactions between Ca(H2PO4)2·H2O and potassium salts under different conditions were also studied. It was found that reactions between Ca(H2PO4)2·H2O and potassium salts might already start as the temperature higher than 300 °C. K2CaP2O7, Ca2P2O7, Ca(PO3)2 and KCa(PO3)3 were identified as main products from these reactions and amounts of them considerably depends on the heat treatment temperatures and mixing ratios between Ca(H2PO4)2·H2O and potassium salts. Compared to KCl, K2CO3 had a higher reactivity toward the Ca(H2PO4)2·H2O under same study conditions. The current work shows the addition of Ca(H2PO4)2·H2O is a promising approach to alleviate the ash sintering issues and assure efficient and smooth combustion of cornstalk.

Investigation on Ash Slagging Characteristics During Combustion of Biomass Pellets and Effect of Additives

Investigation of Biomass Ash Sintering Characteristics and the Effect of Additives

Ash melting and slagging and residual K ion content in biomass pellet combustion

Effect of Ash Preparation Method on the Sintering Characteristics of Ashes from Combustion of Coal and Biomass Blends

The impact of aluminosilicate-based additives upon the sintering and melting behaviour of biomass ash

Effects of Inorganic Additives on Slagging Characteristics of Peanut Shell Pellet Fuel

Quantitative analysis of minerals of blended coal ash at high temperature and its influence on slagging

Effects of torrefaction on ash-related issues during biomass combustion and co-combustion with coal. Part 3: Ash slagging behavior

Impact of ammonium sulfate and kaolin on ash deposition during co-firing of straw pellets and pulverized coal

Behavior of Slagging Deposits During Coal and Biomass Co-combustion in a 300 Kw Down-Fired Furnace

Ash Transformation during Fixed-Bed Co-combustion of Sewage Sludge and Agricultural Residues with a Focus on Phosphorus

Investigations on the Mechanisms of Ash-Induced Agglomeration in Fluidized-Bed Combustion of Biomass

Effect of Sludge Pellets Addition on Combustion Characteristics and Ash Behaviour of Municipal Solid Waste

Morphology and phosphate distribution in bottom ash particles from fixed-bed co-combustion of sewage sludge and two agricultural residues

Reduced Pollutant Emissions and Slagging Rate of Biomass Pellet Combustion by Optimizing the Multilayer Distribution of Secondary Air

Effect of phosphorus-based additives on the sintering characteristics of cornstalk ash

Experimental Study of Potassium Release During Biomass-Pellet Combustion and Its Interaction with Inhibitive Additives

Experimental Study on the Sintering Characteristics of Biomass Ash

Effect of the Coal Fly Ash Blending Ratio on Biomass Slagging Structure Modification and Alkali Metal Migration

Dynamic behavior of biomass ash deposition in a 25 kW one-dimensional down-fired combustor

A comparative study of biomass pellet and biomass-sludge mixed pellet: Energy input and pellet properties