Abstract:Combustion of agricultural residues for heat and electricity production is an efficient way to reduce amount of such waste source and emissions due to inappropriate treatment of them. However, unlike other biomass materials, agricultural residues often have high content of ash and certain ash forming elements with low meting temperatures, resulting in sintering and slagging during combustion processes. It complicates combustion of agricultural residues and restricts further utilization of this renewable energy source. In this work, sintering of a typical agricultural biomass cornstalk and effect of two phosphate additives, Ca(H2PO4)2·H2O and NH4H2PO4, were investigated by a combination of various techniques. Results indicated that the addition of Ca(H2PO4)2·H2O increased the initial melting temperature of cornstalk ash by 64–209 °C. The ash sintering behavior was greatly improved as a result of formation of high melting temperature K–Ca phosphates, Ca9MgK(PO4)7 and Ca2KP3O10 upon addition of the Ca(H2PO4)2·H2O. It is accompanied with reduced generation of low melting temperature K-rich silicates and the formation of large ash aggregates. Addition of NH4H2PO4 increased the initial ash melting temperature by 28–116 °C, but it had slight influence on the cornstalk ash sintering characteristics. The analysis revealed that, although the addition of NH4H2PO4 resulted in the formation of high melting temperature K2CaP2O7, certain amount of K phosphates and silicates eutectics were still formed, initiating and promoting sintering of ash from mixture of cornstalk and NH4H2PO4. Reactions between Ca(H2PO4)2·H2O and potassium salts under different conditions were also studied. It was found that reactions between Ca(H2PO4)2·H2O and potassium salts might already start as the temperature higher than 300 °C. K2CaP2O7, Ca2P2O7, Ca(PO3)2 and KCa(PO3)3 were identified as main products from these reactions and amounts of them considerably depends on the heat treatment temperatures and mixing ratios between Ca(H2PO4)2·H2O and potassium salts. Compared to KCl, K2CO3 had a higher reactivity toward the Ca(H2PO4)2·H2O under same study conditions. The current work shows the addition of Ca(H2PO4)2·H2O is a promising approach to alleviate the ash sintering issues and assure efficient and smooth combustion of cornstalk.

The impact of aluminosilicate-based additives upon the sintering and melting behaviour of biomass ash

Effect of Ash Preparation Method on the Sintering Characteristics of Ashes from Combustion of Coal and Biomass Blends

Mechanism of Na2O/CaO Ratio Affecting Ash Fusing Characteristics During Ash Deposition and Slagging in Municipal Solid Waste Incinerator

The effects of additives on deposit formation during co-firing of high-sodium coal with high-potassium and -chlorine biomass

Impact of ammonium sulfate and kaolin on ash deposition during co-firing of straw pellets and pulverized coal

Ash melting and slagging and residual K ion content in biomass pellet combustion

Investigation on Ash Slagging Characteristics During Combustion of Biomass Pellets and Effect of Additives

Investigation of Biomass Ash Sintering Characteristics and the Effect of Additives

Aluminosilicate Clay Minerals: Kaolin, Bentonite, and Halloysite as Fuel Additives for Thermal Conversion of Biomass and Waste

Effect of Five Different Additives on the Sintering Behavior of Coal Ash Rich in Sodium under an Oxy-Fuel Combustion Atmosphere

Impact of additives in mitigating ash-related problems during co-combustion of solid recovered fuel and high-sulfur coal

Enhancement of ash properties on alkali and alkaline earth metal retention by coal additives in the gasification condition

Effects of torrefaction on ash-related issues during biomass combustion and co-combustion with coal. Part 3: Ash slagging behavior

Effects of additives blended in corn straw to control agglomeration and slagging in combustion

12th International Conference on Fluidized Bed Technology EFFECT OF ADDITIVES ON THE ASH FUSION TEMPERATURE

Role of Al-Based Additives in Controlling Ash Adhesion

Study on Ash Fusion Temperature Using Original and Simulated Biomass Ashes

Effect of Chemical Compositions on Ash Fusibility Characterization of a Jincheng Anthracite During Combustion and Gasification

Effect of phosphorus-based additives on the sintering characteristics of cornstalk ash

Effects of S and Al on K Migration and Transformation during Coal and Biomass Co-combustion

Fate of Na/As along the flue gas path during coal combustion with kaolin addition